Search results

  1. M

    1976 Evinrude 70hp Solenoid Problem

    I have been working on a friends boat for him and have finished restoration and am on to the motor. It ran fine when we took it off the boat a year ago but when i went to start it up i got nothing, no solenoid click or anything. Have juice going into solenoid and i get juice from the ignition...
  2. M

    1977 Mercury 1150 Throttle Adjustment/Tuning

    I got my 115 merc all hooked up to the boat started right up on the first try after sitting all winter. The problem is with the throttle response. Shift lever works ok and shifts all 3 positions smoothly but the throttle doesnt seem right. The warm up lever doesnt move anything until it is...
  3. M

    1995 Kawasaki SS 750 engine and drive into a different hull

    I bought a 1995 Kawasaki Super Sport (SS) 750 last summer. Engine ran good all sumer long. My brother hit something near the end of the season and the hull of the ski is completely trashed. After recovering it from the river we were able to get the motor running again so the engine and all...
  4. M

    1977 Mercury 1150 WOT

    I haven't used this motor much since I got it because I have been restoring the boat it will be used on. I am trying to find out what the manufacturers suggested wot range is. I want to get a new prop for it but need to know the appropriate wot rpm range but cant seem to find the answer...
  5. M

    1977 115hp Trim/Tilt?

    I recently purchased a 1977 115hp Mercury with power trim/tilt. The motor runs but trim/tilt was disconnected when i bought it. I attempted to reconnect the hoses and wires but when i did i got nothing. Does anyone have a wiring diagram or any suggestions to help? Any help is greatly appreciated
  6. M

    1971 Johnson 100hp crank but no spark

    I recently boat a 1971 100hp model number 100ESl71C. When i turn the key the starter will engage and crank the engine but i get no spark from any of the plugs. The power pack makes a clicking noise when the key is in the on position not sure if this is normal or not. Also the motor is a hydro...
  7. M

    Removing Lower Unit For 1965 35hp Mercury

    I have a 1965 35hp Mercury outboard and need to replace the impeller. The problem is that i cant get the lower unit to come off. I have remove all of the bolts holding it in place as when as the shift arms up top. I have gotten it to fall about 3/4 of an inch and dont know how to get it the rest...
Top