Search results

  1. H

    WOT RPM for 85 hp 1969 Evinrude

    I own a 1969 Evinrude 85 HP. The manual says WOT should be 5000 RPM. Alot of people in the marine industry say 5500 RPM. Is it a range and I am ok somewhere between 5000-5500 rpm?? Just don't want to burn the old baby up. Any input appreciated.
  2. H

    prop for 85 evinrude

    I have a 1969 85 Hp Evinrude. Its tuned well and runs fine. Its mounted on a 18 ft crestliner, 1974 model, deep v, approx 1000 lbs weight. its a big water, deep draft boat. Right now I am running about 30 mph, trimmed up with one aboard, at 4600 rpm. I think its running a little hot as powerhead...
  3. H

    1969 Evinrude 85 overheating alarm?

    I own a 1969 Evinrude 85 Hp. Anyone know if this engine should have a overheating alarm that would sound if engine is running too hot? Also, how warm should the water be coming from the pee hole. My engien runs fine, but the water is HOT to the touch from the pee hole. Is this ok for this engine...
  4. H

    Evinrude lower unit gear oil...which one??

    I own a 1969 Evinrude 85 hp, electric shift...does a certain type of lower unit gear oil have to be used or will any do? I have heard that some older electric shifts require special gear oil. Can anyone advise?
  5. H

    blue smoke out exhaust of 1969 85 evinrude

    does anyone else have the same engine with similar observation? Feul/oil ratio is 50:1, engine seems to be in good running order with lots of power, not missfiring or running rough. I notice when skiing behind boat, a small amount of blue smoke out exhaust holes, steady but minimal. This normal...
  6. H

    cooling system on 1969 85 evinrude

    I own a 1969 85 Evinrude. I noticed the intake grates for the water pump on the lower unit need to be cleaned. i just bought the motor and when you look through, light can be seen, as well as debris. How are the grates removed? Do they the pop out or screw out or does the lower unit have to be...
  7. H

    1969 85 hp evinrude trim problem

    I have a 1969 evinrude 85 hp. The motor will trim down fine, but will only trim up at slow speeds without being on plane. The trim motor is running fine, just not raising the motor. Is it an O ring problem or hydraulic fluid? Is the fluid easy to change and what type should I use?<br />Also...
Top