Search results

  1. C

    noisy 4 stroke

    have a 2001 EVINRUDE 70 hp 4 stroke that you cannot hear run on engine with cowl off but definately know it's running on the boat. no visible vibrations/loose bolts etc seen. what could problem be
  2. C

    2001 suzuki df70 oil on water

    2001 df70 runs and idles smoothly. no vibrations no codes no lights starts perfectly. while idling back thru no wake zone I noticed there was an oil slick on top of water and son in law said he smelled gas. loaded boat on trailer and investigated for signs of oil leak. none found with top...
  3. C

    1989 70 hp evinrude won't crank

    have a 1989 70 hp evinrude that worked great last time out. drove boat on trailer and drove 50 miles home and parked. 5 weeks later went to start motor and NOTHING happened. Battery shows 12,89 volts, rem,oved battery cable ends ( trimmed and re-stripped ends and cleaned battery connections...
  4. C

    springs for boat trailer

    anyone know where I can find a set of springs for a 1989 LONG trailer. The springs on it are 1 3/4 inch wide and measures 29 inches from center hanger bolt to end of spring. It is a 3 leaf slipper type spring. I ordered a set but when they came in they were 30 inches long ( exactly 1 inch to...
  5. C

    1993 omc not firing

    1993 40 hp omc not firing. coils ohm good at 0.05 primary and 300 ohms on secondary. compression 323 both holes. says to remove black/yellow or black/white wire from power pack to terminal to check firing. CONFUSED because black/yellow wire seems to be coming from kill switch to master plug...
  6. C

    1993 40 hp evinrude won't start

    have a 1993 40 hp evinrude that refuses to start. no spark on either cylinder. compression is 130 on each cylinder. trigger, stator replaced 8 months ago by a " parts changer ". motor was running fine one day and the next it started and went to wide open trottle and it has not fired since...
  7. C

    water leaking

    have a 2000 suzuki 70 hp that is leaking water from lower engine cowl. what could the issue be
  8. C

    disconnecting oiler

    someone please give me CORRECT procedure for disconnecting oiler on '93 40 H/P Evinrude (E40ELETB). Other than plugging inlet supply does the electrical have to be disconnected?
  9. C

    nedd help with fuel problem

    1993 40 horsepower WILL NOT run unless ball is pumped up every 5 minues or so (more often if WOT). Ball has been reeplaced and inline filter in engine has been replaced, still doing the same thing.
  10. C

    engine stalls

    won't run at WOT, pull back and runs fine. 1993 40 horsepower evinrude
  11. C

    fuel problems

    Have a 1993 40 h/p evinrude that comes out of the hole fine and runs fine for 5 minutes or so then starts cutting back. Pump ball back up and all is well for another 5 minutes or so then all over again. Starts and idles with no problems. Any suggestions appreciated.
Top