Search results

  1. I

    2001 f80 missing at all speeds

    I am working on a 2001 Yamaha F80 that is missing on cyl #4. Spark is present on all 4 cyls. When I take #4 plug wire off, while running, no change in engine sound. Compression on all 4 cyls is 200+ PSI. I have gone thru all 4 carbs and cleaned and reinstalled and still have the same problem...
  2. I

    5.0 Litre EFI TBI 2000 water blockage5.0 litre 2000 Mercruiser cooling question

    I am working on a 2000 5.0 litre Mercruiser I/O with a brovo drive. a number of years ago, I had a problem with this boat overheating and found the water inlet from the IO was collaped, I repaired it and all was well for a few years. Most recently, this engine has had all new manifolds and...
  3. I

    Yamaha HPDI 2001 Z200TXRZ

    I am working on a pair of 200HP HPDI's 2001. It all started with bad gas in the tank. I cleaned tank and all fuel filters, VST, injectors, Etc.... They both ran allright after that. Then they stopped running. I got the starboard engine running again by taking the high pressure mechanical pump...
  4. I

    Force 120HP exhaust (fire) coming from fuel pump pulse port

    I am working on a 120HP Force OB about 1999. Would not idle, so R/R carbs, cleaned and retested. Result was high rpm's & popping and high surges coming from the fuel pump, enough to make the fuel bowl on the top carb spit out of the air vent on carb. I have never seen this sort of problem...
  5. I

    power steering not working

    I am working on a late model 29' Searay with twin 5.7 EFI's. The power steering is not working correctly; very stiff. This is what I have done so far: Removed nut connecting steering cable to cylinder and tested cable for stiffness (cable moves freely). Checked for free movement of cable end at...
  6. I

    What year is my Honda BF8A

    Could someone please tell me what year is my Honda BF8A Engine ser. #BACE1303198 and Frame ser#BZBC1402191 Thanks in advance!
  7. I

    yamaha overheating

    Long story, short! 115Hp 1992 yamaha. good water pump flow (pee hole strong). new thermostats, poppit valve checked (OK). 120-130 PSI all 4 cylinders. Saltaway used several times. Never had impeller break apart. My next move will be to remove heads and water passages and clean. Any other ideas...
  8. I

    kohler genset 4CZ23

    This genset will not keep running after start switch is returned to the run position. I have check all emergency shutoff senders (i.e.high temp, low oil pressure etc...). I think there is a rectifier that turns the AC from genset to DC 12 volts to keep the genset running after it starts to...
  9. I

    2002 df40 wandering rpms at 3000rpm

    I am working on a 2002 DF40 EFI. when the throttle is raised to 3000rpm, in nuetral, then the engine RPMs fluctuate from about 2800 to 3200. Below this setting and it seems to smooth out. To me is seems like it could be a fuel pressure problem. No codes are present. Does not seem to be an...
Top