Search results

  1. T

    86 force 125 bogging at WOT

    Hello, Ive got an old force engine which has been a pain in my ***** since day one. Anyways now after checking the fuel system and ignition system the motor will bog down at wot. It starts fine, idles fine, and will run fine at low rpm. when the throttle gets to 3/4 to full it just doesn't...
  2. T

    86 125hp Lower unit seal part number?

    Hello all, Ive got a 86 force 125 outboard which needs new lower unit seals. I took it apart last year to replace the shift yoke and when I put it back together It never ran at full power and leaked gear oil. After sitting for a winter the case is blue from oil leaking out around the prop...
  3. T

    Shift linkage help!

    I have a 125 force from around 86. I took the lower unit off to have the skeg rewelded and by accident removed the shift arm pivot pin thinking it was the drain plug. Now as I am reassembling the unit I cannot get the shifter to engage anything. I put the pin back in and it looked like it was...
  4. T

    yamaha vx deluxe hull repair

    Last week I hit a large rock with my 09 yamaha vx deluxe. It was a good hit and put a hole in my hull. It is right along the ridge on the bottom about 12 inches long by 4 or 5 inches wide. I can stick my fingers through the hole. My question is about repair. Im sure a shop will cost me an...
  5. T

    Force 125 problems

    Ok last summer I put a serious beat down on this old 125. I lost a prop fin and my skeg. The skeg is completely gone, is there anyway to weld a new one on or will i need a new case? Also the trim tilt motor doesn't seem to be working properly. The motor will go up after a few seconds of...
  6. T

    force 125 damaged

    Hello, I recently acquired a boat with a old force 125 outboard and took it out to the river. As soon as I would throttle up the engine the trim motor would give out and the engine would slam all the way down. In reverse the engine would kick it self out of the water becuase of the trim...
Top