Search results

  1. alldodge

    Looking for Delphi Numbers

    Anyone have a listing of the Delphi numbers which correspond to MEFI numbers? Have a MEFI 1 and always thought it came from my old motor, but just did notice the Delphi number is for a 350. Not that this is an issue because its my understanding that they can all be reprogramed. Did call AZ and...
  2. alldodge

    2012 Cadillac SRX P0442

    The Admirals Cadillac (110K miles) thru a P0442, which can be (from what I read) a vacuum leak in the tank, lines, purge valve, vent valve or canister. Jacked the car up and looked all over the place and could find nothing which stood out. First thing to check was the gas cap. Web says the...
  3. alldodge

    Dodged the Ice Reaper again

    Yesterday was working on the boat getting ready to put it in. Removed a rag placed in the bilge and found a freeze plug laying in the bilge. Started to sweat and put my head further down and noticed the block plug on the port side was still in. Also notice a rusty hole where the plug came...
  4. alldodge

    Water Pressure Gauge Tubing

    Will be installing a 40 PSI water pressure gauge on the block this season. Could use the typical 1/8 OD tubing but its typically -5 to 125 degrees F, for ice maker stuff, -5 to 175F for auto stuff, and -60 to 200F for shore D:70 stuff. The shore D:70 is fairly stiff so this probably won't...
  5. alldodge

    Merc Bravo water pressure

    Wondering what the max pressure that could be seen for or a standard Merc belt driven pump for open cooled system, and measured at the block? Will be installing a mechanical gauge in the block for next season and looking at VDO 30 or 40 PSI gauge. Anyone have one installed and know what could...
  6. alldodge

    Post messages not displaying

    Either the post are being deleted with no signs of post being edited, or some members are not showing up. As an example, porscheguy and QBhoy are missing https://forums.iboats.com/forum/gene...erc-v8-re-prop
  7. alldodge

    HNY and Hope all winterizations were done correctly

    Every year we all read threads about folks having cracked blocks from bad winterizations. With it being so cold for so long I'm thinking the numbers may go up, hoping they do not. In any case Happy New Year and may it be a safe one for you and yours, and there will be no issues come spring
  8. alldodge

    Hope the Heat is Keeping UP

    Installed a new 16 seer heat pump this summer, and with the temps dropping below 30F the heat pump would be going into electric coil mode. Good thing also installed 2 vented propane gas logs. Turned HP down to 66 and the logs to 68. This way the HP does not turn on and the logs take over...
  9. alldodge

    Pergo Flooring

    Installed 1000 sq ft of Pergo flooring. This was the 10yr commerical and lifetime residential. Putting it in a possible rental house and liked the idea its American made and can have water stand on it for 24 hours without a problem. Floor went down pretty well and pleased with the out come...
  10. alldodge

    Chrysler 130

    Keep look for another motor or block to replace my 105. Frank told me I could use a 105 (original) 120 or Force 120 and change my cowling so long as it was before 1994. Found a boat and motor on CL but guy says compression is 132 across the board (skeptical) and its a mid 80's motor. I didn't...
  11. alldodge

    Pintle Hitch

    Over the years I have accumulated all kinds of hitch balls (pun intended). Have the straight 3-way, a couple 2 5/16, variations of 2 inch drops and picked up a pintle hitch some years back when needing a 10 ton Tag trailer. Was out today moving the Tag trailer and an empty cruiser trailer to...
  12. alldodge

    Heat Pump Issue

    Starting to get a house ready for rent and has not been lived in for about 3 years. Has a 2 1/2 heat pump by Rheem. When placed in heat, the electric coils turn on but the outside unit does not. The thermostat lights up AUX on the panel. If I go to cool, outside unit turns on and unit works...
  13. alldodge

    Which Adhesive Sealant

    Trying to decide which sealant to use for below water line trim tab reinstall. Has a 1/2 hole going thru the transom which will have the feed tube to the pump. Removed the old and the sealant was still pliable. Held to the hull and tab hinge very well but felt like and looked like white rubber...
  14. alldodge

    Assuption: RV Antifreeze clogs watercraft

    This is just an assumption, but right now we don't have any other answer. The PWC is winterized by pumping 4 gallons of RV stuff thru the motor. Used RV stuff and not straight antifreeze (exhaust manifold) because of the inner cooler. The PWC didn't get used any last year and sat on an Easyport...
  15. alldodge

    Did I mention I hate log homes

    Buddy of mine has a log home and is trying to get it back so it can be stained every 2 to 3 years. So we have been stripping and sanding for weeks. Doing all this IMO is crap. He never wanted a log home but wound up with one because the wife wanted it. Did I mention I hate log homes So...
  16. alldodge

    Winter water level drop

    Hear folks mention about how low their water level is dropped in the winter. The ones which get my attention are the 12 to 18 inch drop. In my area Cumberland drops around 20 feet and Dale Hollow drops 10 feet. These are averages because they have dropped more when water is needed for...
  17. alldodge

    Grove MZ66 Manlift Info Post Puzzel

    Well bought this manlift some years ago cheap and ran real well, its just old, I need a manual but cannot find one. This post is what I went thru trying to find out what the issues were. The lift has a 4 cylinder air cooled Wisconsin motor, 12V, GM alternator Original Idle is smooth, power...
  18. alldodge

    Logistics

    With all the problems folks are dealing with Harvey, all the very well intentioned people during what ever they can to help is so great to see and hear. The issue I see is the lack of logistics. Everyone is getting a truck load or more of stuff and heading down to Texas and hope also...
  19. alldodge

    Original Poster

    Don't want to add to admins troubles but if it would be easy I would sure like the OP of a thread to show up. Would sure help me to keep from getting off topic by another asking a question
  20. alldodge

    Big and Tall Clothes

    One of my nephew's is a big boy. He is about 7 ft 2 in, and about 480 pounds. Is doing great in the software security world but is having major issues finding clothes. Anyone have any insight where to look for casual button shirts and dress clothes? Shirt is a 7 XLT
Top