Search results

  1. bayliner33

    50hp force water pump disc purpose?

    I just got done installing all new seals and a water pump on a 88 force 50hp, i seen in the diagram a water pump disc, which was not on it when i tore it apart. My question is what is it's purpose, and it is needed. Thanks in advance.
  2. bayliner33

    88 force 50hp 507x8d upper drive shaft replacement

    88 force 50hp, 507x8d, im pretty sure i got a new bearing in my sights i will know shortly, but my question is how to remove the old one. My thoughts are a slide hammer? My seloc manual does not cover this.
  3. bayliner33

    88 50hp force stabilizer?

    Can anyone tell me which stabilizer hydrofoils fit this. I was looking at the stingray on peice, or the se sport 300., both bolt ons.? Thanks for any info.
  4. bayliner33

    86 Volvo Penta 2.1 cam torque specs?

    Hi, I was wondering if anyone has the cam shaft torque specs on the 86 Volvo Penta 2.1, it's a AQ125B. I searched on the forum and didn't turn up anything. Thanks.
  5. bayliner33

    omc 2.3l engine swap to 86 bayliner bowrider

    Hi, I got A 86 bayliner I/o bowrider it has a 2.1 Volvo penta engine and drive. I need to know if I can do a complete drive train swap. I can get a omc 2.3L engine, & omc cobra sx outdrive and controls from a 87 Sea Ray Seville. I want to see if this will fit my hull (transom). Thank's for any...
  6. bayliner33

    85hp force motor runs when put in gear shuts off

    Well I got my 85hp force motor (1987) to run, and idles fine, but when I put it in gear forward or reverse it shut's off. I drained flushed and refilled the lower unit from the bottom up so there is no air in it. When I drained it there was no trace of water, or shavings. When in neutral prop...
  7. bayliner33

    electrical stator and trigger testing what setting for meter ??update!!

    hi i'm not sure what to set mulitimeter at to test the stator, and trigger I'm not sure if it's dc 2vlt/20vlt, or ohm's not sure what selection. I'm working on a 1987 85 hp force outboard motor. any help is greatly appreciated. I do have the manual to tell me how, and what wires to test, but it...
  8. bayliner33

    what is this???? pics included

    still new to boat's, wandering what this is?? it is clamped in the main fuel line right before the motor, think it might be some kind of quick fuel disconnect in case of fire or something??? here are some pic's , did not see anything in manual about it. any info would be helpful about it's...
  9. bayliner33

    87' 85 force engine gear box

    hi I was wandering if someone could tell me how to drain the lower end (aka) gear box so I can change oil and inspect it, while i'm waiting on carb kits, fuel pump kit, plugs, and new spark plug ends, trying to go over every inch, I ordered a manual but did not receive it yet. the prop turn's in...
  10. bayliner33

    85 force compression

    hi i'm in the middle of getting an 86' 85force motor to run it has sat for years, guy said it was run last year. I have got it to start once it did back fire a couple of times before starting but not while running. Imwaiting on carb kits soon as I figure out where to get them. But my question is...
Top