Search results

  1. 8

    Unable to turn over : 1991 4.3 OMC Cobra

    Hello, Just picked up a 1991 SeaSwirl, Cuddy, with what appears to be a 4.3 L V6, and a OMC Cobra stern. Went to go turn the engine over by hand after removing all the belts, just to see and it moves a little, but seems to be binding. I checked it was in Neutral, the prop spins freely, I put...
  2. 8

    Dual engine used boat recommendations?

    Hello all! My wife and I have been playing around with little rinky dink boats over the years (Most of them $under $1000, 86 capri bayline I think 19 ft., a couple 25 HP outboard fiberglass 15 footers), and my wife and I have decided to get a "real" used boat. One we keep for a while. We...
  3. 8

    Old 1970's fiberglass boat with no paint - Ok to test on water?

    Hello, Just picked up a small 15 ft fiberglass boat with a steering wheel and an outboard for basically nothing. The paint on the exterior hull above and below the water line has been sanded down to bare fiberglass. We want to take the boat out tomorrow for a quick test run to see if...
  4. 8

    Do I need to remove Volvo Penta 225E and 275 outboard to look at transom?

    Hello all, Got a 1986 19 foot bayliner capri, with a Volvo Penta 225e (Looks like a GM 5 liter) and a 275 outboard. I had a crackling floor above the gas tank, so I ripped out the floor, and it seems to be isolated only to the floor. There was no water protection on the bottom of the foor...
  5. 8

    Volvo 270 with Volvo Penta 225D upgrade?

    Hello all, I have a 1986 Bayliner Capri with an old carburated Volvo Penta 5.0 225D, with a Volvo Penta 270 connected to it. We used it last year, and had a great time, but I am going to tear into it this year and fix up a few things. While I am tearing into it, I was wondering if there...
  6. 8

    AQ225 idles good, dies with some throttle

    Hello all, I have a 1986 AQ225D, with a quadrajet I just purchased re-manufactured off ebay. I just replaced the fuel filter, fuel pump, starter, and alternator. I have set the timing to 8* and triple checked it multiple times. It starts and idles great! But if I give it any gas, it falls...
Top