Search results

  1. J

    Prop blow out, needing help

    I have a 92 20 hp Johnson short shaft, last year I kept having trouble with prop blow out at about 3/4 speed, the prop was wore pretty bad so over the winter I put a new 3 blade 10x13 on it. I ran the boat yesterday with blow out just one time out of 5-6 runs, so I moved the motor trim pin up...
  2. J

    Needing Help

    I have a 1992 20 hp Johnson its a j20crend. First question. Is it ok to put some kind of screen over the front of the carburetor? Im afraid that something might get sucked into it. Next question. If the motor is tilted up as if you trimmed it up a little or after its been on the trailer with the...
  3. J

    Shallow water drive

    I have a j20crend 1992 20 hp Johnson, i was wondering if automatic shallow water drive can be added to this motor. If so does anyone know what parts are needed. Thank You.
  4. J

    Prop spining out

    Hope im posting this in the right spot if not then i appologize. I have a 14ft flat bottom boat with a 1992 20 hp Johnson motor. The trim plate on the motor while sitting on the trailer is about 2 inches under the boat,the prop is a 10x13 aluminum prop. At WOT the prop want to spin out about...
  5. J

    Kill switch

    I have a 1992 johnson 20hp pull start only,i am looking for a kill switch for it,i would like to find just the switch with a pig tail. Does anyone know where i could find one? I have seen the universal switches but im not sure if they will fit in the hole where the OMC switch goes. They want...
  6. J

    Please help Figure this one out,your a hero

    Ok my boat mechanic and myself are stumped. I have 1986 Evinrude 9.9 electric start,it runs fine except at wide open throttle then it will run about 50 yards and act like its running out of fuel,the minute you squeeze the the gas line bulb it takes off and runs about 50 yards again. What we have...
  7. J

    Needing help electric start

    I have 1992 johnson 20hp Model j20crend, i am wanting to add electric start to it. I dont know anything about what parts i would need. So my question is what parts do i need and what are the parts #. I would really appreciate any help on this.
Top