Search results

  1. S

    Will not turn over with all plugs on.

    Thank you RBoyd1971 and Faztbulet, I have already tried car jumper cable direct from battery to starter, bypass starting circuitry, but make no difference.
  2. S

    Will not turn over with all plugs on.

    Yes, they are go together, there's no mixing of the rods or caps. They are carefully marked as pair before disassemble. What else could you think of that cause the problem?
  3. S

    Will not turn over with all plugs on.

    Hi Racer one, By eye. I connect rods to shaft one by one, turn shaft while tying the cap, making sure there's no friction, or any change to the shaft until cap bolts torque to specs. I follow Seloc book instructions, but use my common sense when rebuild the motor. Could you explain more for the...
  4. S

    Will not turn over with all plugs on.

    I did disassemble and recheck crank shaft, main bearing, rod bearing, and check for sign of piston hitting the plug,... but nothing suspected. Dowel pins for the main bearing were properly seated, aligned.
  5. S

    Will not turn over with all plugs on.

    Hi Chief Petty Officer, Thank you for your prompt reply. But starters, batteries, electrical connections were carefully inspect, check, and swap many times still make no difference. I attached the videos, but do not see them in the post. May I send the videos to your mail address? Regards
  6. S

    Will not turn over with all plugs on.

    NEED HELP !!! I am new to marine outboard. First time I completely rebuilding a 1982 70hp Johnson outboard. I am quite good experienced with car engine and transmission rebuild though. After careful put thing together, I have problem with cranking the motor. The motor turns freely with no plug...
Top