Search results

  1. H

    Rebuilding evinrude 60hp 60073D

    Hi all Well after alot of headaches with trying to get the old girl running properly rebuilt carbs,going through all electrics ect ect After buying a new compression tester and getting low comps 80 75 70 ive just pulled the powerhead down.a few broken bolts in the process and after seeing the...
  2. H

    Ignition swap 1970 60hp 60073D to 1974 70hp

    Gday all Just a quick question Can I swap my 1970 60hp 60073D 3cyl ignition with a 1974 cdi ignition Can get a donor motor so it has everthing on it If it can be done is there anything i need to do Cheers
  3. H

    1970 evinrude 60hp rebuild or not rebuild

    Gday all After alot of replaced parts and time spent,im now seriously thinking of a rebuild. My engine is 1970 60hp 60073D electric shift Rebuilt gearbox Rebuilt carbs New plugs,coil, I did a compression check after all this was done No 1.......65psi No 2........75psi No 3........70psi The...
  4. H

    1970 60hp 3cyl bogging when throttling up

    Gday all Ok all electrics ohm checked Carbys rebuilt New coil New plugs New fuel tank,lines,pump Points at 10 thou WOT set 20 degrees with advance at stop,plugs out throttle at full Throttlelinked Timing sincd Engine starts well and idles very slightly rough,engine revs well when in neutral...
  5. H

    1970 60073D 60hp evinrude

    Gday all After finding the ignition coil has 3 cracks around the insulation and bad wires,in Australia there are no coils available unless someone can point me in the right direction, Cheers
  6. H

    1970 60073D shutdown

    Gday all Finally got the 60hp all up and running, rebuilt gearbox,all working fine. Had problems with the electric shift switch so replaced with two toggle switches, All great. Got out on the water running beautiful got up to full speed for about 2 minutes then it just shut down. Engine was...
  7. H

    1973 evinrude 60073d blowing main fuse

    Gday all Have aproblem with the main fuse at the engine blowing when i turn ignition on Gearbox not bolted up yet after rebuild so hydroelectric shift wires disconnected. When the shift selector wires are not connected at throttle remote the engine will start ok. Have checked the ohms on...
Top