Search results

  1. flashback

    Mercruiser shifter

    Remove the out drive, when the lower cable was replaced a sticking shift shaft would have been evident.
  2. flashback

    Mercruiser shifter

    The shaft bushings seize up and can cause the shaft movement to be too tight. Don't know why.
  3. flashback

    Mercruiser shifter

    The upper shift shaft may be binding enough to trip the switch.
  4. flashback

    Chainsaw Carving

    Mighty fine work!
  5. flashback

    Advancements in peddle boats?

    Most I've seen are two passenger with a paddle wheel in back and a bimini top. I hadn't realized there not made anymore.
  6. flashback

    Mercruiser shifter

    If it's a new to you boat someone probably disconnected the interrupt switch because the lower shift cable is binding up.
  7. flashback

    Advancements in peddle boats?

    Hobie makes a peddle kayak that's pretty cool.
  8. flashback

    Exhaust port mud dobber coming out of it-2005 Johnson 30 hp Outboard Motor 4 stroke

    Not to worry, fire it up the cooling water and exhaust will wash it out.
  9. flashback

    I/O (Sterndrive) Conversion to Outboards

    Did CY say what the reinforcement would consist of. That could possibly be a major task.
  10. flashback

    Solar panel wiring questions

    @nola mike has done this
  11. flashback

    I was going to use Rust-Oleum Topside Paint, but then I accidentally discovered COMET cleaner..

    The grapevine says bleach,/comet is hard on the vinyl and stitching so be shure to treat it with 303 or something similar.
  12. flashback

    I/O (Sterndrive) Conversion to Outboards

    When i was a kid my dad had an inboard Chris craft about 25 ft. With a 283 inboard. It was an easy boat to maintain. Handled real good accept at slow speeds. The rudder was kind of dinky.
  13. flashback

    I/O (Sterndrive) Conversion to Outboards

    Mutiny might work. Us tars have rights!
  14. flashback

    bow navigation wire runs through the railing… where does it come into the main section?

    Deck fittings are installed before the cap is fastend to the hull. So that length of wire was probably run from the bow pulpit when the stations were mounted, my guess is it runs down from the nearest stantion to the light on the starboard side.
  15. flashback

    bow navigation wire runs through the railing… where does it come into the main section?

    Where is your bow light mounted?
  16. flashback

    Time for my first bellow change, tips?

    i remember seeing an old thread describing exactly that, but don't remember who posted it.
  17. flashback

    1976 Montego 16- The "Free" Puppy

    Good times, your havin a ball with that old gal!
  18. flashback

    I/O (Sterndrive) Conversion to Outboards

    You've got everything else set up just how you like. Why not have the outboards. I get it.
  19. flashback

    NS5b gears (F,N,R) and manual tilt

    Probably need a manual, sounds like the shift shaft is mii-aligned
  20. flashback

    I/O (Sterndrive) Conversion to Outboards

    Something tells me your not happy. You have poured tons of labor and cash into this boat, what do you want.
Top