Search results

  1. G

    Please help

    My tach is reading 0 with key off when I start my engine tach goes to 4000 rpm seems to go up when I hit the gas but goes back to 4000 it's a 77 70hp Johnson tach lead is hooked up to yellow wire from stator and has good ground and battery wires thanks for any help I'm putting in Tom for test...
  2. G

    Please help!!! Tach question

    Can someone help The seloc book I have says the gray wire leaving the control box goes to terminal #2 is the tach lead this wire does go there there is supposed to also be a yellow wire with gray stripe leaving same terminal going to the stator however this wire is on terminal #3 with another...
  3. G

    Tach hook up

    Does anyone know how to find out how many poles my engine has so I can set the dial on back of tach I have a 77 70 hp Johnson model no. 70el77s thanks
  4. G

    Exhaust housing to power head

    Can someone please tell me where I can find a exhaust housing to power head gasket for a77 70 hp Johnson trying to put her back together ASAP thanks for any help Greg
  5. G

    Tach hook up

    Can anyone tell me where to hook up wires on a 77 70hp johnson
  6. G

    Please help motor/pump unit trim/tilt

    Help me find a website to buy reman. Prestolite motor and pump for early model single ram system thanks for any help Greg
  7. G

    Power trim and tilt pre 78 J/E

    Can someone point me to the website for a 77 70 hp prestolite motor and pump replacement this is the single ram unit pre 78 motor and pump as 1 unit thanks PLEASE HELP!!!!!
  8. G

    Evinrude ID

    I just bought an Evinrude outboard can someone tell me yr and hp it's a 7077es thanks Greg
  9. G

    Lower unit compatibility

    Will a 50 hp lower unit work on a 70 hp
  10. G

    70 hp jet drive conversion

    I have a 77 70 hp I found a jet drive lower unit driveshaft length and splines are same is there anything else I need to do for this to work
  11. G

    70 hp Johnson lower unit

    Can someone tell me why some 70's model 70 hp lower units have a square looking block behind cavitation holes and other models don't and what is it
  12. G

    Shimming tool#315767

    Can someone please give me measurement for the shimming tool so I can use a ditgital caliper to shim my unit thanks it's for a 77 70 hp Johnson also why would the unit have to be red hummed I'm replacing forward gear pinion gear and clutch dog isn't the new pinion gear the same size height wise...
Top