Search results

  1. O

    3 bank charger on 24 volt system

    I used to run a 12/24 volt trolling motor using my 3 bank charger. (the charger came with my Ranger boat, the charger is made by "Charging Systems International".) I have now switched to a 24 volt trolling motor. So, now that I've switched to 24 volt, do I keep a pos and neg charging cable on...
  2. O

    Trolling motor wiring

    I've replaced my old trolling motor, and when installing the new one I noticed the plug needs replaced as well. I went to my local marine dealer looking for a replacement plug/ receptacle, and they talked me into not using a plug and just wiring direct to my battery. Apparently, "all the guys...
  3. O

    Livewell Plug?

    I have a leak in my live well plumbing. Specifically, its the O-ring around my cartridge pump. Until I replace the live well pump, my plan is to insert a plug on the outside of the boat (where the water intake is located). The water intake port appears to be 5/8", and it appears to be...
  4. O

    "Check Engine" warning light

    I have a 1996 ranger 462 vs, w/ 1996 Johnson fast strike 150 hp. When I start the engine using the starboard fuel tank everything is fine. If I switch to the port side tank my "check engine" light is illuminated along with the 10 second horn. The alarm sounds almost immediately after starting...
  5. O

    boating in the winter?

    Here in Ohio we're having 55-60+ degrees of sunny weather. These days are warm enought to fish. My concern is that it still gets cold at night (below freezing). What should I do to the boat/motor after boating to prevent damage from a cold night (I have a fiberglass bassboat)? How do you...
  6. O

    leaking carburetor

    I've got a 1997 150hp fast strike. Today I ran the motor with the cowl off, and notice gas leaking when I pumped the ball. I'm not sure if gas is leaking from more than one place, but I definitely know I've got a leak from a tiny hole located in the carb bowl. There is a tiny ball in the...
  7. O

    Bearing failure?

    I just re-packed my trailer bearings. (I'm hoping everything was done correctly!) Unfortunately, I'm leaving for a long trip the day after tomorrow (350 miles), so if things go bad I'll be far from home when they do. Here's my question, how many miles should I go on a test drive to...
  8. O

    Master Cylinder replacement

    I just bought a ranger boat/trailer. After realizing the brakes weren't working, I inspected the actuator and noticed there was no fluid in the reservoir. In fact, it was dry and looked rusty. I've filled the reservoir, primed the master cylinder, disconnected the line from the cyclinder, and...
  9. O

    Maintaining value of a fiberglass bassboat?

    I am considering buying my first fiberglass bass boat (pre-owned, less than 10 yrs. old). My problem is that I dont have a garage. Right now the only place I have to store a boat is under a carport (with no sides). Ideally i would have a garage so it is fully protected from sun, rain, snow...
Top