Search results

  1. flyingscott

    1995 Mercury 25hp 2 stroke issues

    What is your compression? Clean your carb and get a OEM carb kit that includes the primer and fuel pump gaskets. Then make sure the ball and spring are in good condition. Unless the reed valve is broke no need to replace them. And if you have one broke you will have bigger issues
  2. flyingscott

    NGK BUZHW-2 replacement

    The QL78v is a resistor I believe
  3. flyingscott

    Quick question

    Mix 50-1 then and make sure the oil nipple is plugged.
  4. flyingscott

    Quick question

    Is there an oil tank anywhere? All OMS systems had a separate oil tank. Don't just assume because the pump is there the injection is hooked up
  5. flyingscott

    The Sharrow is back

    External dead link removed
  6. flyingscott

    McCulloch Leaking Filter Bowl

    isn't that a flat gasket? If it is make sure that groove is spotless. Then go find a rubber flat washer that is fuel resistant
  7. flyingscott

    1991 25hp evinrude starting issues

    Advancing the throttle? Pushing the key in while starting?
  8. flyingscott

    1991 25hp evinrude starting issues

    Tiller or remote mode!?
  9. flyingscott

    Will Replacing Rings Increase Compression >105PSI?

    I doubt that would be a good running motor with only 105 psi. How fast is the starter spinning? Both plugs out?
  10. flyingscott

    Setting gear lash/engagement 2000 johnson 2 str 40hp 2 cyl

    That tool is around $300 if you can find it. Buy a factory manual and all the info you need will be in there
  11. flyingscott

    Setting gear lash/engagement 2000 johnson 2 str 40hp 2 cyl

    Cheaper to take it to a dealer and have them do it for you.
  12. flyingscott

    Lower bearing end float and bearing shim

    A factory manual should tell you that.
  13. flyingscott

    Fuel restriction alarm

    Those sensors in the pump can go bad. There is a replacement sensor but I don't remember the #
  14. flyingscott

    Fuel restriction alarm

    Why not? Do you know how a VRO tank works?
  15. flyingscott

    1990 90 hp Mercury. Beeping when key turned on.

    Those are notorious for the sensor in the tank failing. Unplug the sensor wires and see if the beeping goes away. Run on premix until positive the oil injection is working. And get the carbs cleaned before anything else. Those motors do not have a history of oil injection failure.
  16. flyingscott

    Remove midsection

    If it's the exhaust plate on the side of the power head it may come off by just taking the bolts out. If it's the gasket under the power head you have to pull the power head off.
  17. flyingscott

    1994 Mariner 60hp

    How is a 06159317 serial # a 1994? For the last time put a pic up. You have 5 posts on this motor. Why are you trolling? Several times asked for pics.
  18. flyingscott

    2000 Mercury 90hp 4 stroke pro series

    You will hear it called making oil. The motor runs to cold and can't burn off the condensation. All that excess ends up in the oil pan and Yamahas seem more prone to that. So before anything check your thermostats.
  19. flyingscott

    Evinrude fuel pump conversion kit

    They make a replacement VRO style pump that does not have oil injection for around $160. Sorry I don't remember the part #.
  20. flyingscott

    1958 Mercury Mark 28

    If that is a 28A you HAVE to buy the manual to change the impeller. Also special tools needed. This site has everything you need. http://www.johnsmcintoshvintagemercuryoutboard.com/
Top