Search results

  1. K

    Head bolt torque

    Greetings Am replacing a head gasket on a 1975 25hp evinrude. Can someone give me the torque setting to use on the bolts? Thanks....Kevin
  2. K

    15hp Mercury 4stroke

    Sorry to sound so stupid but it is important. My 2001 has a small grommeted hole directly in the middle of the cowling on the back of the motor I believe is the exhaust. just started it again today cause goin to Canada with it next week. The hole is spirting out a small bit of water. Is this...
  3. K

    25hp evenrude ....Baffled

    Hello to all I know a little about small engines but am abit miffed with this problem. Have a 25hp Evenrude 70s model that ran great last fall. put it on sstand today to run it and no go. I have good spark and the plugs are getting wet so it mis getting gas. I cant even get it to fire or pop...
  4. K

    Water Pump Question

    Gteetings to all, Hoping someone can give mw some valuable info. Do not know much about small outboards. My son has a 110 merc (9.8hp) Serial # 4128332. Is this a 1983? We plan to take this on a remote fishing trip. Today I put it in a barrel to make sure it runs OK. On idle the water pump...
  5. K

    15hp 4stroke

    Greetings to all I found this motor looking for one to take on Canada trips. My question is: While running this motor on the stand, I noticed it was shooting water out the bottom as well as the out the side where the cooling water usually discharges. Can anyone explain this for me? Havnt seen...
  6. K

    Trim/Tilt Motor

    Iv been busy trying to find a tilt motor for a 1990 40hp Mercury outboard, and not having any luck. <br /><br />Does anyone know where I could locate a new or used one on line?<br /><br />Thanks ...Kevin M
  7. K

    2004 Johnson Four Stroke Idle Speed

    Does anyone know what RPM my new Johnson 4 stroke 60hp should be idleing at? It seems to idle somewhat high. One of the reasons I purchaced this motor is I was told it would troll slower than my two stroke.<br /><br />Right now when warmed up, it idles at around 750 RPM. I asked a mechanic and...
Top