Search results

  1. P

    ATLAS 130 TRIM TILT W/ CLAMP ON ADAPTER PLATES

    Need installation manual.Got this used with no info. Putting it on 1975 Meyers Bay Runner,would like to know what the install recommendations are before I blow holes thru the new transom wood I will be installing. I wrote to T-H Marine but haven't heard back from them.
  2. P

    94 90 hp Force no spark top cylinder

    Swapped input wires on coils, failure followed input wire. I do not have a DVA for testing. Also not much of a CDI guy, this is above my points and condenser skill level. What are the common issues for this problem
  3. P

    94 90 hp Force no spark top cylinder

    Swapped input wires on coils, failure followed input wire. I do not have a DVA for testing. Also not much of a CDI guy, this is above my points and condenser skill level. What are the common issues for this problem
  4. P

    94 90 hp Force stalling out at 1/4 throttle

    Cleaned carbs replaced float needles and fuel lines ran OK. Found out I needed to make sure carbs were re-synced and fully closing after re installing carbs, did that. Re adjusted Idle jets.Starts fine and if throttle is opened quickly it runs like a raped ape. But if I gradually ramp up the...
  5. P

    1994 90 hp Force drive shaft bearing loose

    This one hasn't been in the water for 8 yrs and as far as I know never had lower unit lube changed. Got about 3/4 cup water out it when I drained it, so I knew it may need a new oil seal. After changing lube and running with the rabbit ears within a few days I had lube weeping from three small...
  6. P

    1994 90 hp Force drive shaft bearing loose

    This one hasn't been in the water for 8 yrs and as far as I know never had lower unit lube changed. Got about 3/4 cup water out it when I drained it, so I knew it may need a new oil seal. After changing lube and running with the rabbit ears within a few days I had lube weeping from three small...
  7. P

    79 115 HP Mercury Mystery Hose

    I was in in the process of replacing fuel lines when after removing the starter for access I found these lines. I find nothing in the parts diagrams or Seloc Manual about them. There are two plastic 90s and a tee in the center. They are both cracked in half and also the 90s and the tee are...
Top