Search results

  1. J

    1981 60 hp 2 cylinder johnson

    i was just wondering if my motor i bought needs a thermostat to idle correctly. it idles a little rough and constantly shoots water out the ports under the powerhead from start up. i was told it needs a thermostat to idle correct ? any thoughts on it ?:confused:
  2. J

    1988 force 50 stator peak voltage

    i have a 1988 force C the motor dont seem to idle right so i cleaned carb and replace float needle and idle screw didnt help any so i used my dva meter and im thimking the stator is bad it should read 300v but it jumps to almost 300v the back to 250v and stays could someone tell me if this is...
  3. J

    1988 force 50 chugging at idle

    i rebuild the carb and fuel pump clean recirc system and replaced head gasket. checked reed plates but the only way it will idle good is if air screw is turned all the way in ? and suggestion will be appreciated thanks.
  4. J

    timing pickup point 1978 evinrude 70hp

    how many degrees should the timing be when throttle begins to open on a 1978 evinrude 70 hp
  5. J

    1978 evinrude 70 hp idle

    i just bought a 78 evinrude 70hp cleaned and rebuilt carbs replaced plugs, changed coils, rebuilt fuel pump, change hoses and primer bulb but motor wont idle below 1100 rpm or it will die in gear. and when you go to take off it will bogg and then pick up and run like the wind. im thinking of...
Top