Search results

  1. Scott Danforth

    Help with new Lenco Trim Tab Switch

    No cutting and splicing needed. Only wiring it correctly per the schematic. You have 2 wires swapped So pull the switches back out. Go thru the wiring and make it match the schematic
  2. Scott Danforth

    2022 merc 115 wont trim up

    Then get the factory service manual and check the connections to the relays and switches
  3. Scott Danforth

    Non slip adhesive padding - removal and replacemet

    I originally did stick-on non-skid. Then I added non-skid sand to the top layer of paint
  4. Scott Danforth

    2022 merc 115 wont trim up

    Your boat is under warranty. See your dealer
  5. Scott Danforth

    No spark after points change

    All points need to be filed before you gap them and adjust dwell
  6. Scott Danforth

    Non slip adhesive padding - removal and replacemet

    Acetone soaked rag to get the old adhesive off. You may never find what was there originally
  7. Scott Danforth

    vinyl and foam padding

    If you install foam to the trailer it will keep water against the trailer and rust it out in 6 months
  8. Scott Danforth

    Snap in flooring material

    Seadek is a glue in product
  9. Scott Danforth

    help help help overheating Mecrusier

    The one in the factory service manual
  10. Scott Danforth

    Leak in Hull (found). Would like guidance to repair

    go to the top of the forum. the first few topics are stuck like a postit note. 4th one down is the DIY. go from there
  11. Scott Danforth

    2006 Volvo penta 3.0 glp-e misfire on cylinder 4

    looking at the elbow pic (riser is just a riser, that goes between the elbow and manifold), you need to machine off about 0.020" or more to clean up the surface that is where your leak is coming from.
  12. Scott Danforth

    Should I replace my surge brakes with electric on my boat trailer?

    do you have a brake controller in your tow vehicle? if not, electric brakes wont help until you do electric brakes wont last the 25 years your current set up did. you may want to check. two fully loaded drum backing plates may be same price as two new wheel cylinders. since you have to...
  13. Scott Danforth

    1990 4.3 block and 1995 heads, which rocker tightening specs to follow?

    dont just replace the nuts. make sure the rocker studs are correct for non-adjustable vs adjustable. if the rocker stud is one diameter for the shank and the threads, its for adjustable valve train. if the rocker stud is two diameters, where the shank is larger than the threads, its for...
  14. Scott Danforth

    2006 Volvo penta 3.0 glp-e misfire on cylinder 4

    welcome aboard if you replaced the manifold, you need to replace the elbow as well. also, your pictures need to have the gasket material removed if you are showing the mating surface. so remove the gasket, and use a flat-sanding board to clean the surface additionally, if your boat is...
  15. Scott Danforth

    Prop pitch and diameter

    welcome aboard. I agree with above. unless you bought the exact 48-77346-C1-19 for the next prop, a generic 13x19p wont be the same prop.
  16. Scott Danforth

    Cheapest online decal store ?

    dont buy the cheapest. buy the best value make sure the decal is made with 3M scotchcal if you want the decals to last.
  17. Scott Danforth

    1990 4.3 block and 1995 heads, which rocker tightening specs to follow?

    Looks like the nuts from non-adjustable valve train. in an earlier post, you said you tried to go from zero lash to 1 full turn and you couldnt without the nut bottoming out. that is because your supposed to bottom the nuts and torque to spec on non-adjustable valve train. the 4.3 came with...
  18. Scott Danforth

    Tilt switch on caravelle runabout .

    What motor and controls do you have? Most likely the switch is on the binnacle handle
  19. Scott Danforth

    5.7 alpha knock please listen

    After you pull the drive, if you need to go further, the motor can be out in another 35 minutes
  20. Scott Danforth

    Oil filter socket

    I have an OTC kit with 18 different sockets
Top