Search results

  1. Scott Danforth

    3.7 470 amazing

    The motor needed a closed deck, alloy head, roller cam, adjustable valve train, and a real damper. Because of the large bore, a balance shaft would help
  2. Scott Danforth

    3.7 470 amazing

    If you maintain it, it can last
  3. Scott Danforth

    Alpha 1 Gen 2 Weak Link

    Weak links: Dog clutch Lower gear set Upper gear set Drive shaft diameter Then on RPM, the oiling system
  4. Scott Danforth

    Trim Bonding Cable

    best advice ever. then post the pictures in your iboats thread so when your phone has a melt down (and you did not back up the data), you can at least come here and look at your own pictures.
  5. Scott Danforth

    350 mercruiser stalling when shifted into gear

    have you tried to adjust the lower shift cable and the shift interrupt switch? start there. if you cant adjust it out, buy a new lower shift cable.
  6. Scott Danforth

    Shorelandr VIN location?

    Shoreland'r hasnt stamped VIN's in the trailer since about 1982 or 1982. been a sticker ever since.
  7. Scott Danforth

    How to tel if boat will over heat in the water

    your gauges should be 240-33 ohm from 0% to full scale on your gauge (standard) you then have to pair a 240-33 ohm sender with the right gauge (100-250F ) for example same goes with oil pressure. you must have the correct 240-33 ohm sender to match your gauge. are you reading 0 to 60 psi, or...
  8. Scott Danforth

    3.7 mercrusier 165 horse engine

    is it firing on the correct stroke? if you had the dizzy out, easy to get installed 180 out
  9. Scott Danforth

    Rebuilt Mercruiser 140/3.0 doesn’t have enough power to plane

    normally when a lifter wears that much, the cam is worn as well. glad you found the problem. BTW, in the future, a screw driver, hack saw, a bit of copper pipe and you can make a priming tool.
  10. Scott Danforth

    New Tahoe boats quality

    They are more expensive than they used to be. However I do not have any aditional experience over any Tahoe newer than 2012
  11. Scott Danforth

    Fuel Pump Diaphragm Rupture Hose Type?

    They sell clip on vent tubes to add hosed to your existing spark arrestor
  12. Scott Danforth

    MerCruiser 4.3 Clutch/Neutral

    Two types of controls. With button at base of control arm, or where the whole base of arm pulls outward about 1/4 inch If you do not have a button, grab the base of the control arm and pull outward All I/O controls have a throttle only mode
  13. Scott Danforth

    692 DDEC 111 turbo spirals down?

    first, welcome aboard check pressure drop across the intercooler check compression numbers check injector spray pattern and flow are these waste gated turbos? if so, check the waste gate
  14. Scott Danforth

    help figuring out what prop to buy

    I would run a 3-blade 15" 19P stainless and have it custom cupped.
  15. Scott Danforth

    2004 Mercruiser 3.2 L power loss

    do you mean 6.2? or 3.0, 4.3, 5.0, or 5.7?
  16. Scott Danforth

    9000 ft altitude jetting

    about 27% smaller than you have at sea level. you also need about 27% less pitch. (you are loosing 3% per 1000 feet of elevation)
  17. Scott Danforth

    Fuel Pump Diaphragm Rupture Hose Type?

    some older carbs had the tygon line running to a fitting on the spark arrestor. my OMG was like that
  18. Scott Danforth

    Red Tide

    well, when you come, I know good restaurants and micro breweries we could hit.
  19. Scott Danforth

    Oops! I dropped it. 4.3L merc Thunderbolt IV 2bbl.

    first, welcome aboard unless you dropped it into the engine, its just bilge trash at this point. no way the socket can jump up unbolt the dust shield and get in the bell houseing however it would be a good idea to clean your bilge, especially if you have standing water. you should not have...
  20. Scott Danforth

    Water found in foam cored hull. Does the foam absorb/retain water?

    go to the stickies at the top of the forum sticky number 4, link # 14. read it in its entirety.
Top