Search results

  1. flashback

    Overheating issue.

    Glad it worked out for you, just keep an eye on your temp, you didn't say anything about the size of your tub and could have injured your impeller.
  2. flashback

    No core floor

    I don't know your situation but couldn't you core it as far forward as possible and then run solid glass just for the edge that tucks under the forward section.?
  3. flashback

    Causes for concern?

    Welcome The torn bellows is a good indicator that nothing has been maintained, a complete check up in needed..
  4. flashback

    Noisy water pump? 4.3MPI

    I know, it works very well! It's how I kept my 57 ford running when I was a kid..
  5. flashback

    Noisy water pump? 4.3MPI

    You have to go to Hogwarts to learn that skill!
  6. flashback

    Buccaneer disassembly questions

    If you can mount the motor and line it up to the shaft securely then the cowl is the least of your worries. Just cut a hole and build it to fit..
  7. flashback

    08 Mustang Advice

    I like @64osby suggestion, get ya back on the road and something to do in your spare time..
  8. flashback

    Pedestal Seat Base

    I thought about this approach as well but I don't think my hand would fit through the pedestal base. ... But a young apprentice could do it!
  9. flashback

    5.0 Mercruiser Cutting Out While Underway

    All the above and also put a new water separator filter on it. Water in the fuel can cause some very erratic stop and go symptoms..
  10. flashback

    Pedestal Seat Base

    Toggle bolts might work, if they did it would be easier..
  11. flashback

    Pedestal Seat Base

    You could install a 6 lnch inspection plate near enough to the pedestal so it's possible to reach the under side..
  12. flashback

    Bellows ?

    My previous boat 350 v8 had a tube and it gave a nice sounding exhaust note especially below 1500 rpm.. I want to put a tube on my current boat..
  13. flashback

    Trim gauge creeping higher

    When I had my bell housing off to replace all the rubber bits I forgot to tighten the screws on the sender and it slipped out of adjustment. Maybe yours has slipped.
  14. flashback

    Found piece of metal in exhaust outlet

    OMG! you can get a replacement at home Depot.
  15. flashback

    Noise in head

    Maybe a macerator? All my boats had a porta potty..
  16. flashback

    Prop hitting anode

    Mark the blade that's hitting then remove the prop and re-position it on the shaft and see if the same blade still hits...
  17. flashback

    Alpha Gen II Oil Supply Line Cracked and Leaking

    I'm watching this one, on my boat it would be dang near impossible with out pulling the engine..best of luck.
  18. flashback

    Power Steering Leaking Into Water?

    Good to know, I didn't think the oil would work it's way down thru the water.. Apologies to OP.
  19. flashback

    Power Steering Leaking Into Water?

    How
  20. flashback

    Bilge under floor

    Hopefully he installed the discharge line
Top