Search results

  1. J

    OK to run outboard 1 cylinder not working ?

    OK, here's a good one. Have a BF50 4-storke Honda on a sailboat and bottom carb is not working. If I spray gumout into it motor runs perfect. Have removed and cleaned carb but no effect. May be low speed jet "tube" which is no longer available and notorious for clogging. While I source this...
  2. J

    Twin Mercruiser 5.7 / Bravo 3 Thru Hull Engine Water inlets. Sea Strainer Debate?

    Hi All - Located in Annapolis, MD on Chesapeake Bay. Have a 2001 Monterrey 322 with Twin Mercruiser 5.7 / Bravo 3 setup. Several years ago port motor would slowly overheat and it became apparent raw water hose thru transom is most likely crushed by corrosion. This is a common ailment for...
  3. J

    Used Parts Swap Shop ? Stupid question #300,247

    Hey guys - Question #1: Is there a Used Parts swap shop here? My search is no.... but did I miss it? Question #2: OK... well I guesss.. I am parting out a Suzuki 115hp motor in good shape but bad CDI. This was NOT my motor and have no need for it but I KNOW there are many who could use...
  4. J

    1984 Suzuki DT115 DT 115hp Wiring Main Harness

    Hi All - Still hoping this thread may find some help. I have acquired a 1984 Suzuki DT115hp outboard in fair maybe good shape. . It has good compression and the hydraulic/electric trim system works. I want to see if this motor might run -or- (if not) a partout. But... I need to know the...
  5. J

    Wiring Help to start Suzuki DT115.

    Please Remove
  6. J

    What year is this Tohatsu 8HP

    Hi all - Have 8HP Tohastu on recent purchased older trimaran that I am trying to re-juvenate. Is M8B 3B2 sn# 26126. More out of sheer curiousity but ....any help with year (or closest) would be appreciated. Tohatsu said this motor was never registered. Not sure what that meant. Is there...
  7. J

    Shipping a mid-sized Yacht east coast

    Hi all - Need to ship a 32' crusier from Florida to Wash. D.C. Is 1,000 miles. Boat is 33' long, 12,000lbs and less than 12' wide and under 13' high. Anyone with information to help me. Am getting quotes $$3.50/mile on flatbed. THANK YOU IN ADVANCE !!
Top