Search results

  1. D

    Water leak through shift cable

    I have a 2001 mercruiser 4.3 serial number is unknown due to engine being changed and the number that is stamped on the flame arrestor cover is faded out to where it cannot be read. The serial number for the outdrive is OL783082. The transom serial number is OL886317. I keep having water drip...
  2. D

    Alpha1 gen2 upper shift shaft bushings

    I have a 2001 mercruiser 4.3 with the Alpha 1 Gen 2 outdrive. There serial number of the outdrive is OL738082. I do not have the serial number of the motor as I had to change it last year and when I pulled the old motor there was no tag anywhere to be found on the block. I am having issues...
  3. D

    2001 4.3 liter mercruiser flame arrestor

    ARRESTOR Need help in trying to figure out what would cause so much heat to burn the flame arrestor. We took the boat one day for about 3 hours and the boat ran perfect. We took the boat out the next day and after about 30 minutes the alarm came on. I opened the engine cover it was full of...
  4. D

    1998 Polar 17v

    My neighbor has a fiberglass polar center console with a 115 johnson. Does anyone know if this boat has a wood or composite transom. He noticed a crack in the splashwell area that spans completely across the transom where the splash well turns up on the transom and now we are noticing that the...
  5. D

    2007 18 Foot Larson Fish And Ski

    I went and looked at it today. It has a 115 yami on it. The owner stated that that the boat had none been run in over a year. I could tell by looking at it that it has not been taken care of very well. It had sat outside for its short life and the interiors is black from mildew and dirt. A...
  6. D

    Boat Leaning On Right

    I am having a problem with my boat leaning on the right side after the boat gets on a plane when the engine is trimmed all the way down. When I trim the motor up about half the boat levels out. If I were to move the trim tab to the left a little would that help. Boat is 23' Wellcraft cuddy...
  7. D

    2006 Evinrude 225 E-tec

    I Have A 2006 Evinrude E-tec That I Had Put On In January 2007 Is Was Installed As A New Motor. I ONLY HAVE ABOUT 83 HOURS ON THE MOTOR. While I Was Out In The Boat On Saturday I Started Having Problems With The Engine. We Were Cruising At About 30 Mph And The Check Engine Light Came On I...
  8. D

    Transom Repair

    Has Anyone Ever Heard Of Or Used Nida-cores Pourable Transom Compound. I Found Them On The Web And Was Reading About There Sheets Of Honeycomb For Floors And Decks And Then Found There Pourable Transom Compound. I Sent Them A Couple Of Emails Yesterday And They Were Quick To Respond. They...
  9. D

    Wellcraft 230 Coastal Transom

    I Am New To The Forums I Have Been Reing A Lot Of Forums Of Transom Repair But Have Not Been Able To Find The Answer To What I Am Looking For. I have a 1989 230 coastal walk around. I Have Noticed That When I Raise And Lower My Motor The Transom Is Moving About A 1/4 To Mabye 1/2 Inch On The...
Top