Search results

  1. B

    Accessories don't work when boat in water

    I have an Aluminum Hull Tracker. The FM radio, lights, pumps, depthfinder worked when on the trailer, but not after I launched in the lake. Think its a ground wire between battery and fuse panel. How do I test it? How do I thread a couple new wires through from the rear battery to the console in...
  2. B

    Need a Top (1st) Carb for a 88 Suzuki DT115

    The float pin tower on my carb cracked off. I'm looking for a replacement carb or a housing. It is the top carburetor on the 1988 Suzuki DT115 2 stroke Outboard.
  3. B

    88 Suzuki DT115 bogs under load

    2-stroke DT115, CDI, SN 11502-811598, 1988?, ran reliably for years, bogged down on accel several weeks ago. 4 clean carbs; found a loose jet, but still bogs, seems to be sucking vacuum somewhere. How to find vac leak on throttle shafts? Carb cleaner spray? Has good spark & compression. Throttle...
  4. B

    Mariner 40 Starts then Dies After a Short Run

    When I first start my Mariner 40 (S/N OG402756, 1996 C40 ELPTO), on the trailer with the water ears on, I use the choke. It starts, I rev it with the neutral throttle lever and after 5 - 15 seconds, it dies. If I push in the choke button before it begins to stumble, it will recover for 5...
  5. B

    89 Force 125 fuel pump booster spring?

    My engine model is 1258V9B, model B, and the parts picture online shows it has a booster spring in fuel pump 1st stage, but mine does not have a spring. The Clymers repair manual doesnt show a spring. Should I buy one and put it in? The pump and carbs were repaired by a local shop last year and...
  6. B

    need timing control rod swivel on 89 Force 125 model B

    My plastic swivel broke. It was part of the timing advance mechanism mounted at the top of the throttle tower shaft and there is a stainless steel double threaded control rod with slotted end through it, which connects it to the timing advance. The parts list shows it as part number F499026, but...
Top