Search results

  1. N

    1965 9,5hp Johnson, throttle issues

    I'm not getting full speed when in forward. Does anyone have a parts diagram for the throttle section beside the carb on this motor? Or can anyone tell me how to set the throttle to go faster? Thanks!
  2. N

    1958 35 Evinrude Lark throttle issue

    Hello, I'm having an issue with my motor. I'm not getting any speed out of my motor and every once and a while the throttle seem to kick in and be up to normal speed and then it kicks out again. Anyone have any suggestions? Thanks, Kevin
  3. N

    1968 33hp evinrude - interchange parts?

    Hello, Can anyone tell me what other motors I can use for parts for my 1968 33hp evinrude motor? Thanks
  4. N

    1968 33h Evinrude lower unit oil/water leak

    Hello, I have water getting into the gear case on the lower unit on my motor. I'm going to order the seals for it. Do I have to take the whole lower unit off to fix it or can I just take the lower gear case off and do it from there? Thanks
  5. N

    Late 1960 33hp SkiTwin Gear Oil Leak

    Here I go, I just realized that I took out the pivot pin in the lower gear case housing instead of the oil drain screw when changing the gear case (lower unit) oil . I was out in the boat today and after I put it back on the trailer i noticed a milky colored substance leaking from the front...
  6. N

    33HP, 1968 Rude not starting. FIXED - had low/high needles switched.

    Hey guys, So this is what i've done so far. Took the boat on a trip and when we got back the primer bulb would not get hard. Took apart the motor to get to the carb. Found a small piece of metal in the bowl, float still floated, needle was in the seat. I put it all back together. Took it...
  7. N

    1968 33hp evinrude - ignition/wiring

    Can't seem to get ignition working... there are too loose wires (red, black) at front of motor not hooked up to anything. Battery is hooked up, not sure about where the wires go on the ignition switch either. Can anyone help? I can e-mail pictures if needed.
  8. N

    HELP!!! 1968 33HP Evinrude ignition/wiring hook up?

    Can't see to get ignition working... there are too loose wires (red, black) at front of motor not hooked up to anything. Battery is hooked up, not sure about where the wires go on the ignition switch either. Can anyone help? I can e-mail pictures if needed.
Top