Search results

  1. D

    1976 6hp Welsh Plug

    Hi everyone, maybe someone could save me a whole carb kit and knows the size of the Low Speed Welsh Plug on the top of the Carb on a 1976 6hp 6R76 Johnson?
  2. D

    1997 130 TLRV Trim and Tilt

    Ok my Son's Trim and tilt froze this winter and split the housing. It's a Showa Unit and supposibly a 64E-43800-00-4D the tricky part is the -00-, I can find many other numbers like -04-, -05-, but will they work? It is a 2 wire unit.
  3. D

    1994 60hp Johnson 3 Cylinder, No Spark, Burnt Wire.

    Need some help for an "Off Mainland Friend". 1994 60hp 3 cylinder, VRO (disconnected). She complained that it would not start this year. Was running when stored last fall. It has had some fuel issues, Flooding due to Needle and Seats, while docked, and tank pressurizes. Unhook the fuel line so...
  4. D

    Anyone looking for a Project Islander 221V in Wash.

    https://www.crankyape.com/default.asp?pg=DispSingleItem&ItemNumber=80749 Auction ends tomorrow. $525 so far.
  5. D

    130 HP Over Heating

    Ok help again please. 130TLRV My son hit a rock, and cracked the housing, so I purchased an SEI replacement, bolted it on and went out again. Everything was great before the Hard Water mishap. So following SEIs break in instructions, I decided to make 2 trips to the cabin, 1/2 load each trip...
  6. D

    V4 Oil Transfer Pump

    1997 130 HP Oil Transfer pump quit again. It did in about 2000, change the lift pump and everything was fine. Now it has quit again and I can't Remember how I figured it was the pump and not the wiring. So here is what I know. Engine tank gets low, Engine cuts out, the first time I opened the...
  7. D

    Need help 130TLRV Driveshaft

    So I need some help again. A long storey short, I had to pick up the Misses last Wednesday night. The old 130 died on the way back. The driveshaft bearing packed it in. So now I need a driveshaft for it. The case made it and all the gears. But the shaft and bearing didn't make it. 20"V4 Yamaha.
  8. D

    A Crestliner Question

    Ok so the storey is. I hooked upto the boat last September to go to the cabin with the 14YO boy and his friend. 1998 Crestliner Fish Hawk 1750, with a 130 Yamaha. It had been 3 weeks since I used the boat. The same ritual, back the truck down the same loading ramp. Fire up the boat, drive it...
  9. D

    Gas Vent

    So where can I find a Gas Vent? The screww on 90 degress cap of my gas vent went missing over the winter. So now I just have the threw hull portion of the vent system. 1750 Crestliner Fish Hawk. Black screw on cap. Any sugestions?
  10. D

    Type C lower unit oil.

    Ok I think it is safe to use in a 2000 30HP 2 stroke Yamaha. My seals below my water pump have failed. (Atleast I think these are the seals) TRhe oil gets milky after a summer of 100-200 miles. So I bought new seals this year, and I amm going to replace them. My question is, after replacing...
  11. D

    Apollo Prop won't fit

    Ok I purchased a used Michigan Wheel Apollo prop for my 1997 130 Yamaha. It came with the tapered thrust washer, rubber bushing, splined bushing, and washer for behind the castle nut. So I go and put it on. The thrust washer, then the prop, then the outside washer, then my old Castle nut. But...
  12. D

    Freeing a Salt Water Prop Hub.

    Ok I am a fresh water boater, that has purchased a prop, from a salt water boater. The Migigan Wheel hub is stuck in the Prop. I have tried (as hard as I feel good about) to flip it over and hammer it out with a punch. No effect it didn't even budge. It is the right hub for my boat, so...
  13. D

    Double seal under water pump

    Has anyone else noticed that if you reverse the seals under the water pump. I.E. (cup to cup) fill the pocket with grease, it works better than seal face to face. Where freezing comes into play? I have noticed freezing water breaks the top seal, then the lower unit fills with water the next...
  14. D

    "E10" Observations

    Okay everyone this is what I have noticed since the mandated E10 rule. I have a 1998 boat with a V4 2 stroke outboard. The main oil tank is under the rear casting deck and has a deck hatch can be lifted to get access to it. I used to lift this hatch to see how much fuel I "acuatly had in the...
  15. D

    Tell your outboard storeys

    Here are the motors I have used and the storeys behind them in my life. 1955 5 hp Viking (Eaton's brand Johnson) Top mount tank, ran great until it melted into a puddle of aluminum when the cabin shed burnt in 1995. 1958 Evinrude 10 hp, It would start by pulling through 1 compression stroke...
  16. D

    suggestions please

    Ok so I will tell you what I do know. I run a Crestliner 1750 Fish Hawk, with a 130 Yamaha 2 stroke. When I bought the moter it had the factory Yamaha black SS 13 1/4"x19" prop. It came out of the hole wicked fast and run close to max RPM's which is 6000 RPM for the 130. Operating range is...
Top