Search results

  1. B

    1997 Evinrude 30hp rough at higher rpms

    At idle and at slow no wake speeds I can't notice anything different in the motors sound or idle. However, when I increase the boats speed I begin to feel a vibration in the entire boat from the motor. At full throttle I can only go 17 mph instead of the usual 21 mph. Then I decreased the speed...
  2. B

    1997 Evinrude 30hp rough at higher rpms

    At idle and at slow no wake speeds I can't notice anything different in the motors sound or idle. However, when I increase the boats speed I begin to feel a vibration in the entire boat from the motor. At full throttle I can only go 17 mph instead of the usual 21 mph. Then I decreased the speed...
  3. B

    1997 Evinrude 30 hp model numbers

    I'm going to possibly buy a used '97 Evinrude 30hp motor and couldn't find the serial or model number sticker on the transom mount. Is there any other locations on the outboard that will tell me the model number?
  4. B

    1994 Evinrude 30hp engine cuts out

    My '94 Evinrude 30HP (J30ELERR) will sometimes "cut out" like it can't get enough fuel when I push the throttle lever at take off. It starts great, idles great and the engine has no misses or backfires. What I need to do to get to WOT is very, very slowly push the throttle lever forward, listen...
  5. B

    1993 Evinrude 40hp

    When I run about 4mph in the no wake zones the motor runs good. Nice idle, no sputting, or knocking. However, when I increase the throttle to full the rpm's will only increase a liitle then they will die down and I'm going 4mph at full throttle. I have good compression, and good spark. I was...
  6. B

    1994 25hp Johnson Idle

    The past two times I've been out fishing I can start the engine (electronic ignition) and it holds a good idle. I'll go to maybe 3 different spots to fish (cranking the motor and running maybe a 1 mile or 2 miles each time). When I crank the motor say for the 4th time to go to another spot the...
  7. B

    1994 Johnson 25hp flywheel torque

    Can anyone tell me how many foot pounds of torque the flywheel nut needs torqued?
  8. B

    1994 25hp Johnson motor cuts out

    When I open the throttle up to 90% I have no trouble and the motor runs great with no problems. When I take the throttle to full I can run for about a half a mile then the motor cuts out as if I took the throttle lever and quickly pulled it back. There is no warning by a change in the rpms of...
  9. B

    Pin hole leak in gas tank

    I have a 1994 25hp Johnson and a standard 6 gallon metal gas tank. The tank has the handle on the top of the tank for carrying and 2 steel plates on each side of the handle to wrap any extra gas hose you have. One of those steel plates came off and there is a small pin hole where it was factory...
  10. B

    OMC Control question

    On my OMC control below the knob that adjusts the tension of the throttle is a female plug. It has 3 holes to fit a male plug with 3 pins. That plug is covered with a cap that says "5 amp max." What is that plug for??? :confused:
  11. B

    1994 25hp Johnson cables

    I just bought a 1994 25hp Johnson with electric start and was wondering does the positive wire from the battery go to the solenoid or directly to the starter? It's the end with the red boot. Right? My current motor an 1982 Evinrude 15hp has the positive battery cable going directly to the...
  12. B

    Help, I can't find this part anywhere.

    Can someone tell me where I can find this part for my 1982 evinrude 9.9 (E10RLCNS). It's the hard plastic "plug" that holds the throttle cable as it enters the engine. (See picture) I found the throttle cables on the internet but they don't list this part in the cable kit. Also, its not listed...
  13. B

    Evinrude 9.9 move the starter to the dash

    I have a 1982 Evinrude 9.9 with electric start and alternator. The push button to start the motor is located on the left side of the motor hidden in the mounting base which is the typical location for this engine. What I would like to do is move that switch to the dash by the steering wheel. I...
Top