Search results

  1. P

    Prop does not seat aganist housing.

    Good day mates. I have replaced bearings and seals in my 1964 E-rud 28 hp gearcase. I put prop on for dry run and noticed that it does not seat aganist the seal housing. it is about 1/4" away. of course that is with the pin inserted. What can I do to correct this. I am worried about cavatating...
  2. P

    Pinion Gear Bearing

    Good morning Mates. Well started into the lower unit of my 28 HP. Found several things to include a bad bearing. When I took my pinion gear out the roller bearings started falling out. The pinion gear looks like that of a 68 model versus my 64. Is this bearing incased? If so ,without a puller...
  3. P

    Lower unit oil is Milky.

    Good day Mates and God bless. I drained and put in new oil before the Week end, but when I checked it last night after two trips out, it was Milky looking. What is my problem? I have no leakage around the prop. The second problem with my 28 HP E-rud was surging at high speed. :confused: Thanks...
  4. P

    Long Star Boat Info

    Good day and God bless. I have a 14'6' long star with no ID number. Can any body enlighten me on the company. I know they where in Grand Prarie Texas and Bremen Indiana? It is Alum that I am about to start restoring. Thanks much and kepp it between the banks. Popsrose' Tennessee Hick:rolleyes:
  5. P

    35 HP Cooling Problems

    Good morning All and God bless. My friend has a 35 HP, 1986, I think, (0A965285) that pumps water when it first starts then stops pumping water. Any body got any info on what to start with in repairs? Thanks much!! Popsrose' TYennessee Hick:eek:
  6. P

    64 Evinrude 28 HP Float adjustment?

    Rebuilding this 28 carb. Float bottoms out in bowl. What is the proper level? Thanks much all you water lovers. Popsrose'
  7. P

    1960 10 HP Johnson Black drainage from LU water Ports.

    Al right guys, Here is one on me. I have got my old engine running good. After removal from water. I noticed a black drainage, from my lower unit water ports. Lower unit oil is fine. It is draining onto my blade. It this a carbon build up, or have I lost a seal some where? Thanks much and God...
  8. P

    QS-21 Carb adjustments

    Good day and God bless. I was given a QS21 10 horse. Cleaned carb, cleaned and reset points. Replaced fuel lines. Got good fire. Set lower jet at 1 turn. Set upper jet at 1-1/2 turns. Cranked my but off and not even a wimper. Checked plugs and they were wet. (Flooded I think) Question, What is...
Top