Search results

  1. R

    1994 40HP Force Trim/Tilt flush and change question

    Thanks in advance for help I have a 1994 40HP Force (by Mercury Marine) with trim/tilt. Could someone tell me the proper way to drain, refill the fluid, and bleed the air from the trim/tilt unit? I have also read where I can use Dextron AT fluid in trim/tilt, is this true? Thanks
  2. R

    1994 Force 40HP water pump change question

    Little help Please I have a 1994 Force (by Mercury Marine) 40HP I am wanting to change water pump impeller in. I have the lower unit off and on the bench - question is does the brass retainer on the top of the driveshaft below the splines come off (I have tried to remove and afraid to shatter...
  3. R

    1994 Force 40 HP by Mercury Marine propeller interchange

    Little help Please I just bought a 1994 Force 40HP 2 cylinder, 2 cycle by Mercury Marine, it has the non through exhaust propeller, only numbers I can find on prop are 13 1/2 and (looks like) A20668. Is there any other outboard motors that will interchange with this prop like Chrysler or...
  4. R

    1994 Force 40HP need male 8 pin wire colors Please

    Thanks in advance for any help I just bought a 1994 Force 40HP 2 cylinder power trim/tilt, this unit has a 8 pin female plug on the motor. I have the cable controls with trim/tilt button but the unit had a dash mounted ignition switch separate from the controls and the owner kept it in his boat...
  5. R

    Minn Kota 565W prop

    Thanks in advance for any help. I have an older Minn Kota 565W that takes MKP-3 (3 1/4 inch prop with prop nut A). Is there any other model prop that someone has used before that would work with this motor like a MKP-2? I cannot find much information on older motor.
Top