Search results

  1. J

    84-02 evinrude/johnson 20-35hp drive shaft bearing depth

    When installing new drive shaft seals, I think I drove the drive shaft bearing further down into the housing. Does anyone know the depth the bearing is supposed to be at? The manual calls for special tool 322923 but I can't find it on internet.
  2. J

    85-90 Evinrude/Johnson lower unti shift rod seals

    It is a 25hp. I have a factory service manual but it is not very clear in this area and I was hoping to get some first hand tips on how to replace the shift rod seals. I am going to try and pull the prop shaft carriage to replace the prop shaft seals. Is the shift rod disconnected from inside...
  3. J

    1968 Johnson 55 hp No Spark about to be junk

    I have no spark to the plugs. Had this motor out for 2 hours running and then it quit on me and wont start. I have checked the amplifier and I am getting about 45V from it when cranking which would make sense because I blew up my 12V tester light the first time I checked it. I measure 10V when...
Top