Search results

  1. C

    is a 40 hp Suzuki a good deal?

    A friend of a friend is selling an 80's model Suzuki oil injected outboard. He said he bought it newly rebuilt for $1400. I haven't seen it but have seen pics. It looks really good, gray/green color, with reconditioned prop. He said it has been used half a dozen times since bought. It cranked up...
  2. C

    is a 40 hp Suzuki a good deal?

    A friend of a friend is selling an 80's model Suzuki oil injected outboard. He said he bought it newly rebuilt for $1400. I haven't seen it but have seen pics. It looks really good, gray/green color, with reconditioned prop. He said it has been used half a dozen times since bought. It cranked up...
  3. C

    seafoam? for merc 650

    OK it's been some time since my last post. My fishing boat, a '72 bomber with a merc 650,sat for two months. I tried to run it, it would idle/fast idle all day, would make it out of the slough and start to bog down. I put fresh gas with liquid seafoam in it, and it still bogged. Now my runabout...
  4. C

    rebuild carb on merc 650?

    I had my 72 Bomber crap out on me last month. Would run fast idle but that's it. Tried fresh gas with seafoam and it made no difference. Will fast idle all day but bogs out and stalls when you try and go.Plugs look good. Should I clean/rebuild carb? Shop says $80 a side. I have a manual but it's...
  5. C

    stubborn trim fill bolt

    I have an Evinrude '88 spl and I can't get the fill plug off the trim. I think the trim as some air in the line because it grumbles on occasion. Anyhow, it is a large flathead plug and with my biggest screwdriver it won't budge. Any suggestions?
  6. C

    merc 650 won't run

    I have a '72 Bomber with a 650 merc. It sat since December. I tried to run it yesterday and had trouble. It cranked right up and I fast idled it to warm up. It wouldn't idle(but it never eally did). the problem is once I start to go it bogs down and misses really bad then dies. This is the same...
  7. C

    where's the pee hole on a 72 merc 650?

    Where's the pee hole on an old merc 650?My 88spl rude has it right there on the driver side, bottom of the power head. I can't find a hole, I don't see one with it running.Any info would be appreciated.
  8. C

    How critical is the rubber seal around the prop hub

    I have a merc 650 with a leaking foot. I pulled the prop and the two seals and one looks indented. Everything is still pretty greasy and the foot oil wasn't that foamy. Should I go through the foot? Impeller and the rest of it or just put new seals in it and run it. The rubber on the inside of...
  9. C

    How critical is the rubber seal around the prop hub

    I have a merc 650 with a leaking foot. I pulled the prop and the two seals and one looks indented. Everything is still pretty greasy and the foot oil wasn't that foamy. Should I go through the foot? Impeller and the rest of it or just put new seals in it and run it. The rubber on the inside of...
  10. C

    how much oil in foot?

    I changed my 88spl today. The oil was burnt and very nasty smelling. However, last week my merc 650 foot was full of waterso............How much oil is enough.?I filled it until it came out the top then took a few seconds to screw the bottom plug in. Did I let enough out? After the top...
  11. C

    merc foot full of water

    I drained the foot on my merc 650. Well, I should say I drained the water out, there was no oil. I put oil in it and it didn't leak over night. I put it in the water and you could see it then. Its leaking out of the prop. Could I change the seal myself?
  12. C

    merc 650 steering and throttle cables

    Does anyone one know where I could get a steering cable and control unit for a merc 650? They're shearing away from rust. I had a pare control unit which I took apart to try and swap throttle cables. The cables were too short.
  13. C

    88 spl fuel problems

    Well,<br />It runs fine only with external tank. Replaced fuel line, vent hose,primer,checked uel filter. Does anyone have any advice?Some said pickup but where would it be on an inboard tank?
  14. C

    have begun to see the light with the 88 spl

    Well,<br />I replaced fuel line, inspected fuel filter,looked for anti-syphon valve and checked vent. I put a portable tank in the boat this morning. I headed out , sure enough I got a mile upriver and it died. Switched to the portable tank, and I was off with no problems at all.The main tank...
  15. C

    88 spl continuing fuel problems

    Well,<br />I've changed fuel line and bulb. Pulled off vent hose and its clear. The boat still stalls after running about 10 mi or so . Just stops,vapor lock. Fuel bulb is flat but you can hear it pulling gas. Starts up after the bulb fills and runs fine for a short time but dies over and over...
  16. C

    88 spl continuing fuel problems

    You guys on here have helped me greatly in the past year. I am grateful. Now, I've replaced the fuel line but the motor still dies after running for 40 min. or so. However, now with the new fuel line I have a better idea of what is happening. When the motor dies the primer bulb is totally flat...
  17. C

    88 spl won't start

    I had a problem with my runabout seeming to run out of gas. The only thing was that the tank still had gas in it. So I changed the fuel line and primer bulb(all one piece). Well it seemed to act funny when I primed it like it was flooded. I couldn't tell if the thing was actually pulling gas up...
  18. C

    plug wires

    I have 88 spl rude on my runabout. Will an outboard motor start without all the plug wires attached? Had a problem with gas and replaced a rotten fuel line. After it wouldn't start. I tried to crank it a few times then upon inspection saw a broken plug wire. I have no clue but figured since a...
  19. C

    throttle control on 650 merc

    I have a 74 Bomber bass boat with a 650 mercury thunderbolt. The throttle cable is rusted as is the steering cable. the throttle cable has started to shred. I have another control unit, the whole thing, and its in good shape. but someone rigged a cutoff switch into the main power cable. it looks...
  20. C

    88 spl power trim

    About time to put the ole' glasstream back in the water.It has an Evinrude 88 spl and ever since I've had it the trim has been kinda noisy. It seems that when you lower the motor all the way down it runs real fast until a certain point. Then it slows considerably. If it sits for a while with the...
Top