Search results

  1. S

    1987 OMC Fuel problem?

    I have a 1987 OMC 2.7 Sea Drive. I have an intermittent problem with power. The fuel filter on the motor will only fill to about 1/4 full at idle. Under acceleration this does not change. The problem occurs at approx. 3000 rpm. The motor stops accelerating. It will continue to run and will...
  2. S

    new powerpack is different from old one

    I have a 1986 OMC 2.7 Sea Drive. I am replacing a power pack with new OMC power pack. Old power pack coil leads were discintegrating. My question is the new power pack has a 4 pin plug, a 2 pin plug and a single pin plug. On the old power pack, the single pin plug comes from the side of the...
  3. S

    bad coil power supply

    I have a 1987 OMC 2.7 Sea Drive. I recently found one of the 12 volt leads from the power pack to the coil was disconnected. The end had corroded & fallen off. When I tried to repair it I noticed the copper wire inside the insulation was heavily corroded. My question is can I cut the coil leads...
  4. S

    where do all these wires go?

    I have a 1987 Wellcraft 23 fish w/2.7 liter omc sea drive. had the boat for about a year & have been going through it & cleaning it up. I have found quite a few cut or disconnected wires. some i have been able to trace others no clue. any ideas on tracing wires so i can either use or eliminate...
  5. S

    fuel line types?

    I have a 1987 Wellcraft 23 Fish w/2.7 Sea Drive. I am replacing fuel line from the tank to the motor & was wondering is there any difference in automotive rubber fuel line & marine rubber fuel line? Thanks for any help
  6. S

    Deck hatch lids

    I have a 1987 23 fish with 2.7 omc sea drive. I have several deck hatch lids that are molded into the deck & need to be replaced. anyone have any suggestions to either purchase or make new lids. lids are plywood with fiberglass coating. appreciate any help.
  7. S

    replace vro with standard fuel pump

    I have a 1987 2.7 litre OMC Sea Drive. Oil injection is disconnected & I want to replace pump. am having trouble finding someone who can tell me what pump to buy. also, are there any modifications needed to do this? Any help would be great.
Top