Search results

  1. S

    2005 Johnson 25 hp J25TELSOM Drive Shaft Length

    Can anyone please tell me the length of Johnson part 0351149? It is a drive shaft for a 2005 25 Johnson J25TELSOM. I bought the motor from a guy who has both the short and long shaft parts (supposedly). He bought it with the long shaft and had it converted to a short shaft, but "kept" all of the...
  2. S

    Johnson 25hp pinion gear and driveshaft

    I just purchased a 2005 Johnson 25 hp electric start J25TELSOM with both short and long shaft. The engine was originally purchased with the longshaft attached but the original owner had a mechanic swap out to short shaft. I needed it back to a long shaft so I converted it. Long story short, the...
  3. S

    Exchanging Johnson 25 hp short shaft to long shaft

    All, I have a 2005 Johnson 25 (J25TELSOM) short shaft. I have the long shaft that was orignally on the engine. In the process of coverting back to long. I have all but the two nuts below the powerhead removed. The two nuts are attached to studs that are attached to the top of the exhaust...
  4. S

    1982 25hp Evinrude starves for full at WOT

    My 1992 25 HP Evinrude E25ELCNE idles fine and runs at WOT for a while until it seems as is it is starving for fuel. If I pump the bulb, she jumps right back up to WOT for a while and repeat. Cleaned carb and replaced diaphram. When oredered the rebuild kit for the pump for the E25ELCNE, parts...
  5. S

    1993 Yamaha Waverunner III Starts, idles, but does not speed up

    1993 Waverunner III starts and idles like a champ. When you throttle up in/out of water it makes a duh,duh,duh sound and does not speed up past a fast idle. Also smokes very bad at speed up. Spark tester shows good spark, emptied fuel tank and cleaned, blew out all fuel lines, new fuel filter...
  6. S

    225 DFI 3.0 Lever Assembly (throttle)

    I have 225 DFI (3.0) and don't ask why, but the plastic on the lever assembly broke off. There is a tamper proof screw holding the assembly on, but is super tight. I am sure the manufacturer used locktite. Does anyone know if it was used:cool:? I have ordered the part and need to get the old...
  7. S

    2007 225 Optimax

    I have a 2007 225 Optimax. What is the normal idle range and what should top RPM be. I am only topping out at 4750 which seems low. The boat weighs in at 3150 with a full tank. It runs smooth but does not sem like it may be running on all cylinders. How do I check if I am running on all...
Top