Search results

  1. S

    Trailer suspension

    Hi I have an 70s Fletcher on what I only assume is the trailer it came on. My question is that the suspension is not the indisuspension but a 1 leaf spring across the trailer with 2 stub axles on each end . Can you get these type still and from where. I am in the UK Regards Neil
  2. S

    Mariner 60hp

    Hi again I have found that I need a exhaust gasket for my 1986 mariner 60hp. Serial 9444374 could any one point me to the right part number and best place in uk to purchase please Regards Neil
  3. S

    Cracked casing

    Hi all I need some advice. I have a yam 60hp 1994 . Getting it ready and general maintenance today and found a crack in the gearbox casing just in front of the prop and about 10 cm long . My question is can this be repaired. (Tiger welded) or is it scrap. It is not leaking but do not want it to...
  4. S

    Yamaha 60hp 1994

    Hi I need to change the trim motor on my outboard. I have undone the trim assembly but how do you actually get it off as it seems wider than the bracket itself
  5. S

    Crescent 3 9 outboard

    Hi all I have aquired a small air cooked crescent 3 9 outboard . It needs some TLC and I need to take leg off. Would anyone have any diagrams or manuals for these engines or point me in the right direction . Thanks in advance Neil
  6. S

    Towing u bolts

    Hi all I have a old fletcher. I want to start towing inflatables and perhaps have a go at wakeboarding. I need the harness and u bolts. What is the best setup for a 1970 boat . Many thanks Neil
  7. S

    1989 60hp trim

    Hi I have a problem with the motor on the trim. The relays click as they have always done but now the motor does not run at all. I have tested the wires coming from the relays and the voltage is there as you would expect. Is there any common problems with these motors I should look for before...
  8. S

    Mariner 60 charging

    Hi all I have a Mariner 60 hp that does not seem to be charging. Multimeter across battery shows 12v with and with out engine running. Could any one tell me how to check the charging system as I have the manual but am not sure if I am following right. many thanks in advance Neil
  9. S

    Model id

    Hi there, I know there are charts on here to Id engines but I still cant make out what the numbers denote The numbers are 60FETO 6H2 L 455228 Could any one shed light on what they mean Regards Neil
  10. S

    mariner 30hp 1981

    Hi could anyone tell me why there are three screws on the lower unit . 1 oil level 2 oil drain and 3 wash . What are they for Regards Neil
  11. S

    Mariner 30 hp

    Hi I have a Mariner 30 hp mid 80 serial 30m 689s 009915 I have taken gear housing off to find the small tube is in two parts so I need to order one of those but my question is about the gear selector. I thought I needed to disconnect this before removing the LU but as I did the top part...
  12. S

    Mariner 60hp 1986

    Hi all. I have got a question about my mariner 60hp. I have use the engine and boat for the first time since I bought it a few years ago. After a lower leg oil change a new impeller and case and new plugs it all started up ok and seemed to warm up ok and not get to hot. After I got away from...
  13. S

    Mariner 60 hp 1984

    Hi all I have put my new impeller in the new case and give it all a good clean . Put the muffs on and started the water supply. When I started the engine I expected the water to just come from the tell tale hole but it was coming from the hole and looked like the exhaust aswell as the two small...
  14. S

    mariner 60 hp help

    Hi I am replacing the water pump on my Mariner 60 as all the blades hame come off . Not sure why. But I ordered a kit and cant seem to see where all the seals go I have taken the housing off and been careful to keep everything in order so I know how to put it back together . But how does the...
  15. S

    Mariner 60hp

    Hi this may be a stupid question. When you run an engine should the impeller (tell tale water flow) run with the engine or only if it is in gear. Regards Neil
  16. S

    Battery

    Hi Could anyone advise me of what battery power rating I will need for a Mariner 60hp 1986 engine. Regards Neil
  17. S

    Mariner 60 1986

    Hi I have fitted the engine on the back of my boat (Not connected to anything yet ) I have noticed a red flat strap but this is not connected to anything . Could anyone tell me where it it should go and what it is for. Regards Neil
  18. S

    mariner 60

    Hi I am at a stage now where I am ready for engine to go on hull. Is there any advice on doing this .also before it goes on how do u take the main engine and leg off the bracket to make sure clean and lubed Many thanks Neil . I think its a 1986
  19. S

    Trailer bunks

    Hi there I am rebuilding a trailer for a 15 fletcher boat. I have replaced all the rollers but the two bunks were made of box steel with a plastic cover over them which you can imagine there is no steel now under the plastic. Would you think it is best to just get some more box steel and cover...
  20. S

    Mariner 60 hp

    Hi could anyone tell me where I could get hold of the two screws ( one vent and one drain) for the gearbox as mine are no good. Many thanks Neil
Top