Search results

  1. V

    '84 115hp T-o-P rebuild

    I have an '84 115hp Tower of Power that i am pretty sure has a bad head gasket. Pressure test shows psi borderline spec when cold but way low on one cylinder (6 if I recall) when warm. I ordered a service manual off of Ebay and have done far too many auto rebuilds, so i decided to tackle this...
  2. V

    Repair 1984 forward controls for 115 I6 mariner

    Took the old pontoon out for the first time in a couple of years. After being out for an hour or two I noticed the neutral lock stopped working. I cold go from forward to reverse with out pulling in the lever. I took it apart and it looked pretty gummed up so I cleaned the handle mechanism...
  3. V

    Launching with class b rv?

    Ok, we are heading to Raccoon Lake in Rockville, IN. I have a 24' pontoon on a scissor trailer I will be pulling behind my buddies '97 F450 class b motorhome. How practical is it to launch with the rv? Would I be better off finding put-in service or driving my tow vehicle? For those not familiar...
  4. V

    Godfrey AP2422

    I have a 1988 Godfrey AP2422 Entertainer. Anyone know the difference between the Entertainer and the Executive Cruiser? We bought it with just a homemade bench seat, in the rear. We are looking into pontoon seating and I am curious to see what the factory layout was. My railings are all the way...
  5. V

    24' Aqua Patio motor opinions

    Just picked up a 1988 Godfrey Aqua Patio. It has a homemade 3/4 plywood bench in the rear and currently no other furniture. It has a 1970 70hp Johnson with aftermarket power trim on in. I had an identical 'Rude on my old 16' trihull without the power trim and wasn't to impressed with the...
  6. V

    Mariner Controls Question

    Last year I switched my 73 85hp 'rude to a early 80's (not sure of the exact year at the moment) 115hp Mariner. I am shopping for a used control box including harness and cables. Is there any particular year and HP range I need to look for? It has power trim but that isn't essential as I can...
  7. V

    1984 Mariner 115 hp temp sensor/thermostat

    A friend gave me a 115 hp Mariner inline 6. I mounted it up and made sure it runs, no water out the tell tale. I already planned on replacing the water pump. Am I correct that there is no thermostat on this motor? Also, I found the temp sending wire is taped off in the harness. Is there a place...
Top