Search results

  1. golbrick7

    1996 Johnson 70hp outboard motor (J70TLEU) fuel pump

    My 1996 70hp outboard motor (J70TLEU) currently has a VRO fuel pump. Have disconnected the oil tank and pre-mix oil in gas tank. Is there a regular fuel pump I can use to replace the Original VRO pump as it needs replaced.
  2. golbrick7

    Motor tries to kick up going forward

    I have a 70hp Johnson on my 21' pontoon. Why does the engine try to kick up when going forward? Plenty of water depth.
  3. golbrick7

    Pontoon LED Headlights

    I would like to add LED headlights to my 21' pontoon bow and stern for fishing at night and docking. Want something really bright. Looking for advice on watts/lumens. Any advice would be appreciated.
  4. golbrick7

    1996 Johnson 70hp Outboard Motor - J70TLEUM

    Have severely damaged the lower unit on my 1996 Johnson 70hp Outboard motor (Model # J70TLEUM, Serial # G04259762). Looking for a rebuilt. If anyone has one available please provide picture and price and how I can get it to Tipton, Oklahoma, 73570.
  5. golbrick7

    1996 Johnson Outboard Trim/Tilt

    Own a 1996 Johnson Outboard, model J70TLEU. How do I check and/or fill my Trim/Tilt fluid? Any help would be appreciated.
  6. golbrick7

    Compatible GPS for Corbra MR F45 D

    Own a Cobra MR F45 D VHF radio. Looking for a compatible GPS that would show way-points and reverse tracking. It only has a black and red bare wire lead that plugs into the radio.
  7. golbrick7

    Power Trim Motor

    Just purchased a new API 440 ABN Power Trim Motor and Resavior to replace my old worn out one. What oil is recommended to use in this unit? Thanks in advance.
  8. golbrick7

    Trim/Tilt Hydraulic Pump

    Have a 1976 19' Hammond Ski Boat with a 165hp In-Line 6 Mercruiser Marine (4.1 Liter 250 CID) engine with a 1970-1977 Pre-Alpha Model 165 R Outdrive. It still has the original High Pressure/Low Volume Trim/Tilt Hydraulic pump. I believe the motor to the pump has gone bad. Will not raise...
  9. golbrick7

    Electric Horn Hook Up

    Want to add an electric horn to my boat with a momentary push button switch. Is there a simple way to do this?
  10. golbrick7

    Mercruiser Service Manuals

    Does anyone know of a file sharing site where one can download PDF files of Mercruiser Service Manuals 90-71707 and 90-95693?
  11. golbrick7

    Best Way to Clean Flame Arrestor

    I have a Bendix ZenithUSA B175-60 Flame Arrestor on my I/O engine. What is the best way to clean it? Thanks in advance, Joe,
  12. golbrick7

    Battery Switch

    I want to put a battery switch between my two 12 volt batteries so I don't drain my start battery during night fishing. They are currently hooked up in parallel. Which wire do I put the switch on between the batteries (+) or (-)?
  13. golbrick7

    Raising/Lowering Lower Unit

    I currently have a "Up/Down" switch that raises and lowers my lower unit. It even works when the ignition is off. The "Up/Down" switch has 3 wires coming from it. I would like to add a gauge so I know what position my lower unit is in. My gauge has 4 connection points: "S", "I", "GND", and...
  14. golbrick7

    1970-77 165 R-Drive Outdrive

    I have a 1970-77 Pre-Alpha 165 R-Drive Outdrive, Serial #4630028. Want to replace the Limit/Sensor Senders. Wiring is completly gone from each sender but have a Push-Button Up/Down switch that raises/lowers my outdrive with no problem. Want to add a guage to my dashbord to let me know what...
  15. golbrick7

    Mercruiser 1.6R Outdrive - Pre Alpha

    Need to replace my Trim Limit and Trim Sender Switches on my Pre Alpha 1970-1977 Model 165 R-Drive. Wires from both switches completely gone. Purchased new set. Want to by-pass all existing wiring in boat. Need help connnecting the 2 wires from each to pump, battery, gauge. Can anyone help?
  16. golbrick7

    165hp Mercruiser In-Line 6 Oil Sender

    Want to by-pass exisiting wiring due to corrison, rat bites, etc. Would like to hook up oil sender to oil temp gauge. Can anyone help?
  17. golbrick7

    Fuel Pump Rebuild Kit

    I have a 165hp In-Line 6 MerCruiser Marine engine in my boat. S/N 0A608351. When in neutral engine runs fine but as soon I as put in gear and apply power the engine bogs down and dies. It runs fine when doing about 5 miles per hour. I'm told this pump is 862077A1, OEM P/N 0509408. Is there...
  18. golbrick7

    Install Trim Limit & Trim Senders

    Bought a new set of Trim Limit and Trim Senders and want to by-pass the existing wiring due to corrosion, breaks in current wiring, and rodent chews. Have two wires coming from each of the senders. Can anyone help in connecting these directly to the battery, gauge and pump? Sure would...
  19. golbrick7

    Rewiring Tilt/Trim & Fuel Gauges

    I have a 1976 I/O Tri-Hull. The exisiting wiring is either corroded, broken, or eaten by rodents. Want to directly rewire my Tilt/Trim and Fuel gauges. Have new Trim and Tilt Senders, Fuel Sensor, and gauges. My fuel tank has a ground terminal on the tank. Can anyone help?
Top