Search results

  1. X

    NJ Trailer Registration

    Has anyone registered a NY trailer in NJ. The previous owner had it registered with the state of NY. I plan on buying it and registering it in NJ. Is there anything I should make sure I bring or be aware of ? Thanks.
  2. X

    Triton 2286 Trailer Size

    Hey guys i am looking at buying a Triton 2286 without a trailer. I need a trailer and am unsure as to what size roller trailer i should buy ? The boat is a 2286. Thanks.
  3. X

    2003 200 HPDI with 197 hours

    I am looking at a boat that has a 2003 200 HP Yamaha HPDI. Is there anything i should be concerned about with a 2003 engine with only 197 hours ? Should i look elsewhere ? Anyone know what I should be looking for to see if this engine will last me a while ? Thanks.
  4. X

    Mariner 135 Lower Unit Vent Leak

    Once again I have an issue with my 135 2stroke V6 outboard. I had a mechanic replace all gaskets, and seals. They did a pressure test and did not find a leak in the lower unit. I also had the prop and prop shaft and gear case replaced. I can't figure out what is going on with this vent leak...
  5. X

    1992 Mariner 135 V6 Prop Size ?

    Went down to Atlantic Highlands Muni Marina and took off the shrink wrap and began getting the boat ready for spring. I have decided that I would like to replace the prop this year. I am trying to determine the proper size/pitch. I cannot see any size information on my current prop it looks like...
  6. X

    Mariner 135 stalling when in neutral only ?

    I have a Mariner 135 V6 on my last trip the engine started fine while i engaged the throttle into fast idol (Cold Start), but everytime i dropped it into neutral it would stall. We did notice though it would not stall in neutral if we pumped the primer bulb while it was running in neutral it...
  7. X

    Octane for Mariner 135 V6

    Hey I have a Mariner 135 I usually run 91 octane in it and it runs well. 91 octane is hard to find in my area and it is becoming inconvenient to use. Can anyone recommend another octane that will be okay to run and will not cause me any problems ? Thanks
  8. X

    Mariner 135 stalling right above Neutral ?

    Hey i have a mariner 135 that runs great. But sometimes when i drop it to neutral or right above neutral it stalls. It is not all of the time that it occurs but usually once or twice a trip. Just had it tuned up and had compression tests done. Had good compression and everything else seems fine...
  9. X

    Mariner 135 SparkPlug Change after Winterization

    Hey guys, this is going to be my first spring start up after winterization for my 135 Mariner Outboard. I have heard that I should replace the plugs. I am new to outboards and boating in general. Does anyone know what size and how many sparkplugs this 135 takes ? Also is there anything else to...
  10. X

    Bow Rail Replacement ?

    Hey guys hope everyone has a Merry Christmas. I have been looking for a new bow rail for my 1999 18ft Angler CC and havent had any luck. Can anyone point me in the right direction ? My last resort will be getting one custom made but I would much rather find a bow rail from a salvaged Angler or...
  11. X

    Quicksilver throttle cold start button?

    Hey guys i have been having trouble starting my mariner 135. We have recently replaced both fuel filters. We think we may not be starting the engine properly through our quicksilver throttle. I have been reading about a cold start button on the throttle or some type of button that is used to...
  12. X

    Mariner 135

    Hi guys just recently bought a CC with a Mariner 135 hp. Saturday was our first time testing it out and we had trouble starting the engine. We finally got it started and let it idle for about 10 minutes but as soon as we put the engine in drive we could not get the engine started again. We lost...
  13. X

    Drain Plug Releasing Alot of Water After Use

    Hi guys I just recently bought an 18 ft Angler CC. I have heard many mixed reviews about the Anglers. But It is all I could afford at this point. So my concern is that i recently launched the boat for the first time and removed the drain plug before launching and put it back in right before we...
Top