Search results

  1. J

    evinrude blew up!

    i have a 1989 40 horse rude. its blew up. i am going to get a used motor. question: what all motor will just bold right up and use the shift cables and all other wires? isnt there a 35,40,48 and 50 and 60 that will go right on it? and what year range? thanks!
  2. J

    40 horse evinrude 1989 with VRO

    when i am running down the lake wide open, it will just start slowly slowing down then get to a point where it just dies. then it will not run but at about half throttle even though it is wide open.<br /><br />i took the carbs off and cleaned them today so i know it isnt that.checked fuel...
  3. J

    89 40 horse evinrude

    let me tell you what this motor is doing.<br /><br />i will be running wide open down the lake at around 4800 RPM's and it will just start slowing down about 100 RPM's every 30 seconds or so till it hits around 3000 and it will just die.<br /><br />there is no cracking or popping.<br /><br /><br...
  4. J

    89 40 horse evinrude motor problem

    hello !<br /><br />ill explain what this motor is doing.<br /><br />ill be going down the lake and running at around 4800 rpm's. and it will start gradually slowing down, like losing 100 rpm's every 30 seconds. then once it gets down to 3000 or so it will just die. it wont idle anymore. and you...
  5. J

    89 40 horse evinrude motor problem

    hello !<br /><br />ill explain what this motor is doing.<br /><br />ill be going down the lake and running at around 4800 rpm's. and it will start gradually slowing down, like losing 100 rpm's every 30 seconds. then once it gets down to 3000 or so it will just die. it wont idle anymore. and you...
  6. J

    50 horse yamaha question

    there is a little steel wire coming out from behind a plate on the lower left of the motor stadning behind the motor. it just grounds to a screw on the outside there.it comes off a thing under that plate with a rubber bushing or something on it.<br /><br />this wire broke. is it needed ? do i...
  7. J

    do i need this rubber seal?

    when i put my lower unit back on the seal popped off but i did not see it until the thig was back to gether. do i need it on there. 89 40 horse rude.
  8. J

    question!!!

    i put my lower unit back on and to my surprise, the little rubber piece that the shift rod goes through pop off and was laying there. is this piece neccessary? i dont see where it seals anything and the bottom of it is clean. if not i have to take the whole thing apart again!!
  9. J

    another small impeller ques!!

    do you have to scrunch the impeller to get it to go down in the impeller housing? in other words is the impeller bigger than the housing? thanks
  10. J

    couple questions!!!

    1. what does the vro do. 2. my tilt trim is slow to rise but goes down normal. is it low on fluid.
  11. J

    shift rod removal!!

    89 40 horse rude. i have an overheating problem. i bought an impeller. im going to try myself. the bolt is up under the carbs. would it be best to take the carbs off to do this? any tips or advice?thanks
Top