Search results

  1. C

    50ESL73R No Spark

    I am almost at the end of my tolerance with this motor. I had a combination of problems recently (ignition and fuel). It took me a while to get that sorted out. I replaced the stator, rectifier, and timer base. That fixed the spark problem, and then there was a bizarre fuel issue that ended...
  2. C

    50ESL73R Fuel Pump Question

    My fuel pump is bad. The sheet metal check valves (reed valves) are rusted through. Last year I bought one from amazon. It was supposed to match exactly, but it didn't There was a port on the back that I assumed was for a pressure tap when it was mounted flat to the engine. Mine isn't, it is...
  3. C

    Tune Up Specs 1973 Johnson 50HP 50ESL73R

    Hi Guys. I have read a great deal on this forum, but I don't have a lot to contribute. I am still learning how different outboards are from automotive engines. I have googled a lot trying to find out the tune up specs for this engine. It is running OK at the moment by finding specs in...
  4. C

    1973 Johnson 50ESL73R very low power

    This motor is severely lacking power at anything more than 1/3 throttle. This is what I have done. New spark plugs, stator, rectifier, timer base with sensor, cleaned and adjusted carbs, cleaned and inspected fuel pump, replaced all fuel lines & bulb, and has fresh gas. Timing is perfect...
  5. C

    1970(?) 120hp worth rebuilding?

    I bought a 120hp Chrysler model 1207HA S#4997 from an auction. Two of the cylinders are scuffed and would need to be bored and new pistons, but the top cylinder is actually cracked. About 1-1/4" to 1-1/2" in from the cylinder head. So two questions. 1. Can a cylinder be welded and bored? (I...
  6. C

    Johnson 50hp bog out and die above half throttle

    It is a 50ESL73R It was (supposedly) rebuilt a few years ago. When I first got this engine it ran great for about 20 minutes. Then it started losing power at higher throttle settings. Now it will bog out and die above about 1/3 to 1/2 throttle. It will start and run fine at idle and high...
  7. C

    120hp 1970(?) Wires to connect to start

    I bought a 120hp Chrysler model 1207HA S#4997 from an auction. It has Magnetron ignition with points. All I got is the motor. I put it in a barrel and tried to start it but no spark. I checked out the points and was getting no electrical contact across them. Cleaned them up and they appear...
  8. C

    1954 Johnson Seahorse 5-1/2hp CD10

    I need a head gasket, carb kit, (packing for the needles if it isn't in the kit), and a float for a 1954 Johnson Seahorse 5-1/2hp CD10. Anybody know where I can find them? Thanks.
  9. C

    45hp Chrysler losing power at full throttle

    Hey guys. I have a 45hp Chrysler 2 cylinder about 1978 vintage. It has had a fuel problem for a long time that I haven't been able to figure out. After priming, it will idle and run at low throttle settings very well. The first time to try for cruising speed, it will take off ok, but after...
Top