Search results

  1. S

    1986 Chrysler 125 hp Force falls on its face after a few mins.

    it will come out strong after a few min. it will cut out and will only go as a troll. just as a heads up i have all ready checked the following compression is great check for spark replaced the last coil due to no spark rebuilt carbs getting plenty of fuel took it to marina they set carbs and...
  2. S

    1986 Chrysler 125 hp Force

    Motor runs fine but after about 10 minutes or so, it will only go at a trolling speed--then is coughs and sputters, wont accelerate and then cuts off. After that it will clear out and run fine. Thought it was bad gas but it keeps happening, checked plugs-appear to be fine, carbs are brand...
  3. S

    1986 Chrysler 125 hp Force

    Hi all, just sold my 14' Sea Nymph with 1996 Evinrude 25 hp---i am in the market for something quite a bit bigger where older isnt an issue. Found a nice 1986 cc Bayliner Trophy with a Chrysler 125 Force (running well). Any takes on this particular engine or any common probs?
  4. S

    25 Evinrude only allows 1/4 to 1/2 throttle?

    Just replaced the whole water pump, thermostat and gasket, and new spark plugs... motor still doing the same. Wont let me throttle more than 1/4 to 1/2. In neutral it is fine, but once in gear it sputters and pops and acts like its not getting fuel. What could be the cause of this?
  5. S

    Water pump replacement kit with a little plastic piece????1996 Evinrude 25 hp

    Was that little plastic piece supposed to go somewhere in the water pump I just installed? If so what is it and where does it go? Any help would be greatly appreciated! 1996 Evinrude 25 hp Model E25REDA
  6. S

    1996 Evinrude 25 hp not pissing out the top

    Already changed water pump and dropped the lower unit twice :p blew air through the bottom hose and felt air at the top... what else could it be? Thermostat was bad, took it out for now just to see if I could get it pushing water. Any help would be greatly appreciated.
  7. S

    That darn lower unit...somebody help me please

    So I have the lower end off my 1996 Evinrude 25 hp and now I cant get the water pump off because there is a coupling or something stuck on the end of the shift cable line thing. Do I have to disassemble that part too--cause I have already started and it hasnt helped? Man this sucks!!
  8. S

    Newbie on boat motors....

    Looking for some help on a 1996 25 hp Evinrude thats not pumping water (model 1448EO). From what I have read many say its the water pump... locating the water pump is where my problem is. I own my own mechanic business so I am mechanically sound, but working on a diesel engine is a lot different...
Top