Search results

  1. R

    chrysler

    20 hp chrysler autoelectric that shuts down at high rpm and restarts imediately.
  2. R

    japanese mariner

    I need wireing color code as to wire colors for a 1989 japanese 40 hp mariner 2 cyl ser# 503832 40elto. The motor had the wires cut to wire in to internal side controls and the motor was replaced with a 75 hp mercury. Thank you
  3. R

    1988 evinrude 150 ser#150stlcca

    I have a evinrude that runs great at idle, but won't get up on plane, acts like it is flooding, I checked dva voltage on both sides of stator and get approx 170 volts, havent checked at high rpm. can this stator be breaking down at high rpm, I have cleaned the carbs? This motor has been...
  4. R

    mercury 2000 remote controls

    I am haveing a problem repairing a set of controls that the fast idle does not work and I believe the controls are not put together properly, goes in gear and throttles up but no fast throttle for warm up. Does any one know of a website that shows diagrams of this control? side mount 2000. Tjank you
  5. R

    evinrude 150 1988

    I had posted a water pumping problem on this motor, I found that the copper tubeing was bent and was going off to the side of the guide tube. How stupid of me, all the other evinrude and johnsons the tube went in the guide without looking. But it is fixed and I learned not to overlook such...
  6. R

    150 evinrude

    I have a 1988 150 e150stlcca that won't pump water. I bought this motor on a boat and the motor had been extremely hot, the lower unit was off. I checked the impeller and it didn't look all that bad, but I bought a new impeller and o ring and installed it and I started the motor and it ran good...
  7. R

    60 hp mercury 3 cyl

    I have a 60 hp mercury that I can't make heads or tails about the serial numbers, can you help? serial # 6129438. Thank you
  8. R

    old sportwin outboard

    I have a old evinrude sport twin plate # 3012-14950 What year and where do I get a carburetor kit? the fuel is leaking around the primer shaft. THANK YOU FOR ANY HELP
Top