Search results

  1. S

    '94 115 Evinrude V4 Power Head to Mid Case Water Leak / What Seal??

    Just finished rebuilding the engine, the engine started right up and runs very well, but I have a water leak somewhere at the mid case to power head junction. The water indicator is shooting a good stream, and the engine is circulating water. No leaks at the thermostat housing. No leaks above...
  2. S

    GLM Head Gaskets / 1994 Evinrude 115 V4

    Does anyone know if the GLM aftermarket head gaskets need an additional gasket sealer applied? The GLM gaskets are shiny which I assume is an impregnated sealant?? The factory OMC service manual calls for coating both sides of the head gaskets W/ "OMC Gasket Sealing Compound” Since these are not...
  3. S

    Intake / Exhaust Port Chamfer Size For .030 Overbore

    Recently had my '94 Evinrude 115 bored .030 oversize, I believe the ports need a new chamfer but don't know what size the chamfer should be. Just looking for a general place / idea where to start on a dimension, break the sharp edges with say .01 or .02 chamfer?? Appears like this could be quite...
  4. S

    Hard Starting 1996 Evinrude 115 V4 W/ VRO

    Hello all new to this forum, I've had this motor for 3 years now & it's always been very hard to start. I had not used it much this summer, but today was beautiful (low 70's) so I took the boat out & could not get it started.<br />Would sputter & die, the starter eventually got so hot it burned...
Top