Search results

  1. S

    4 HP Evinrude Coils

    Hi. I have an early 80s 4hp Evinrude outboard, on which the coils have stopped working. The ones fitted have the number 510961 stamped into them but i can't find any replacements with this number. Were they superseded with a different part number, or is there another number that will suffice...
  2. S

    Evinrude 18hp fastwin torque setting

    Hi,i have a 1970 18hp Evinrude fastwin,and i need the torque wrench setting for the crankshaft/flywheel nut.Kind Regards Phil
  3. S

    Torque setting

    Hi,can anyone tell me what the torque poundage should be on the crank/flywheel nut on an 18hp fastwin please.Kind Regrds Phil
  4. S

    Evinrude 18hp issues

    Hi and good day to you all.I have a 1970 18hp evinrude fast twin,the problem i have is that when i try to start it,i move the twist grip on the tiller arm to the stop for starting,but the cam on the base plate is nowhere near to opening the carb to the necesary amount of opening,if i open the...
  5. S

    Evinrude 18hp petrol oil ratio

    Hi,i have a 1970 evinrude 18hp,i have been using 50:1 petrol oil ratio,but it seems to emit a lot of smoke.Is this the right ratio,any help much appreciated.Regards Phil
  6. S

    Johnson 70hp 1978,reverse and tilt lock

    Hi,I'm quite new too outboards,as i've had inboards before.I now have a powerboat with a 1978 70hp outboard fitted,but i think there's some bits missing,as i think there should be some kind of lock lever for when in reverse,and a lock lever for when the outboard is tilted on the trailor and...
  7. S

    Johnson 1979 70hp Holes in gearbox!!!

    Hi All,Can anyone tell me if, on the gearbox looking from the rear of the engine on the r/h side,if there should be 2 holes,1 just above the curved bit,that the prop shaft runs inside,and one nearer the front just below the cavitation plate.They are perfectly round about 5-6mm in diameter,which...
  8. S

    Evinrude 18 hp won't start, update from may16th post.

    Hi All,The engine will run for a few seconds,but only if i remove the carb and spray premix directly into the inlet manifold, when i replace the carb it won't run,not even if i spray premix into the carb venturi,i've stripped the carb, blown all the airways and gallerys out,and it still won't...
  9. S

    Evinrude 18 hp starting problem

    Hi All,I have a 1971 18 hp that won't start,it has new plugs and points fitted and there is a big fat blue spark on both plugs,there is 115 compression on both cylinders,however when you remove the plugs after 6 or so pulls,the lower plug and cylinder are wet but the upper ones arn't,they are...
Top