Search results

  1. A

    IMPELLER IN OUT DRIVE

    MER CRUISER 5.0 305 CI 2002 MPI 240 HP ( CANT FIND SER NUM) I LOOKED IN THE MANUAL A DONT FIND WHAT I'm LOOKING FOR. Q ? DOES A BRAVO THREE DRIVE HAVE AN IMPELLER IN THE LOWER UNIT? I ASK BECAUSE I AM OVER HEATING DUE TO GROUNDING AND HAVE A NEW IMPELLER, THERMO STAT AND NEW RISER AND...
  2. A

    scrap it or fix it

    I have a 1985 wellcraft 20 ft with a 3.7 merc engine that is frozen. been trying to free it up but no luck so far. my question is: should i scrap it or fix it.? I'm pretty good with tools but would need help to change the eng. I just don't know if its worth it, alot of work to put in a used...
  3. A

    elect choke on carb

    V20 mcm 3.7 242 cd 165 hp The diagram I have shows from choke bottom screw to gnd . gnd? I have purple wire to choke but didn't have a gnd before i had it rebuilt..
  4. A

    elect choke setting?

    I got my new part for the elect choke and yes it was missing a gasket:mad:. Q. Is the setting on this critical to make it work? I know about where to set it but I did not mark the old one:grumpy: Q. Can I start at some position and then move it later? Thanks as always...
  5. A

    My elect choke connection is grounded?

    Checking on why my eng wont start I find that the connection from the wiring harness to the elect coke connector is grounded. I had my carb rebuilt and now wont start I traced it to this point.. Any help would be appr...Thanks In Adv...
  6. A

    Power to fuse panel

    I'm having trouble with wiring at the dash board esp with the fuse panel. Q... Where does the fuse panel get its power from?.. I looked all over some diagrams i can't seem to locate the source of power coming into the panel... 1985 V20 stepup with a 470 mercruiser single bat. volt meter, no...
  7. A

    tourque spec

    1987 mercruiser 3.7 l4 165 HP I need torx spec for the exh manifold thanks
Top