Search results

  1. N

    gelcoat chipping

    I have a 1996 Champion bassboat that has about a 1" spot near drain plug that has been chipped down to the fiberglass. The chipping came from bumping a rock while trolling backwards to retrieve a lure. My question is what can I use to repair the damage to the affected area? Fiberglass does...
  2. N

    200 efi oil injection

    Hello everybody. I've recently bought a 1996 Champion bassboat with a 200 Mariner EFI. The boat has only been in the water 15 times, so the engine is fairly new. I've looked over the motor pretty well and just have a few statements about this engine I would like to elaborate on.<br />1. No...
  3. N

    need a Electric fuel pump

    I have a 1996 200 Mariner EFI outboard motor.<br />The electric fuel pump is froze up in the vapor seperator tank. I used the Seafoam for 2 days to no avail. The part number I need is 809088 1.<br />My serial number for motor is OG325292 and the Model# for motor is 7200413ED w/20" shaft. The...
  4. N

    91 skeeter transom damage

    Been a while since I've used site.<br /> I recently bought a 91 Skeeter bassboat with rotted transom wood. I took the rub rail off and drilled out all the rivets for the cap but having a hard time lifting top off of hull. The cap is loose all the way around the boat and I'm able took pick up...
  5. N

    water telltale

    Went to lake yesterday and noticed while at WOT that the telltale was spitting water, not a steady stream. Backed off the throttle and water was a steady stream again. The motor is a Johnson 150 GT (YR 1988 V-6). I had recently changed the impeller housing and impeller, along with 2 new...
  6. N

    tourquing exhaust cover bolts.

    I've just put new head-gaskets on my 1988 Johnson 150 GT and have replaced both exhaust cover gaskets. I got the tourque correct on my head-gaskets (ft lbs) but do not have (in.lb) tourque wrench (cost $69). Is there a conversion from (ft lbs) to (in lbs). The (in lbs) for exhaust cover bolts...
  7. N

    engine rebuild or buy remanufactured

    Ran boat last sat. Boat ran 67 mph but would not idle for nothing. Checked compression on my Johnson 150 Gt (88yr) model after warmup and checks were not good. 80 95<br /> 85 90<br /> 70 85<br />I pulled the head off and looked at #6 and...
  8. N

    warm up lever on 150 johnson (88yr)

    I've looked through alot of topics and can't find what I'm looking for. Last time I went boating I pushed primer w/key and pushed up the warm up lever to warm motor up like usual. Motor fired up like normal but for some reason I couldn't get the motor to rev up like normal, it stayed at one...
Top