Search results

  1. brnschoneck

    No muff holes on chrysler 1970 55hp

    So this may sound stupid however my first chrysler motor ive owned ..There is no place for muffs i beleive the water inlet hole is in the front triangle shaped pretty big hole,I think this is the hole that sucks water up correct ?? ??? Is this,kinda on top of propellar under cavitation plate, so...
  2. brnschoneck

    thoughts on 70 chrylser 55hp is it a good motor ??

    I am looking at buying a 70 maquis fishing n ski 16' with a 70 55hp chrysler that has been well cared for at least the last five yrs i know for sure ..Just had carbs rebuilt new batt new bilge pump quistion is is this a good motor for the year ?? I dont know much about chryslers but i knonw i...
  3. brnschoneck

    Timing quistions for dots on 65 merc 650 kf whats what ????

    So im preparing to check my timing .. looking at the carbs with the flywheel on tdc to the right i have two sets of three dots one set about a inch the other maybe a couple inches,then to the left i have one set of three dots ??Does anyone know which set is btdc and atdc and degrees of what is...
  4. brnschoneck

    Throttle cable replaced / adjustments ??? 1965 65 hp merc

    While im having this bog down prob... i replaced my throttle cable as it was all shot becouse the motor did not respond until i had it pulled up about half-way is this right ??? also then when i put it in f , after it goes into gear right away but i have to push a little further maybe a inch...
  5. brnschoneck

    1965 merc 650 ?? what would u do ???

    Ok so heres goes end of last year boat ran fine started coughn,hesitating ,bogging etc when throttled up..So i figured well i better clean carbs n check points....Took starter off dropped distributor housing down cleaned points,rebuilt carbs, ran fine "better" on muffs no hesitating i did only...
  6. brnschoneck

    ohm meter reading when doing max advance at tdc

    ok so at btdc .222 with ohm meter connected advancing magneto untill points are open how do I know what will ohm meter read or do? ?? I am getting a constant beep then it jumps to a higher number n back down is this when there open book just says wen they start to open as indicated by meter I'm...
  7. brnschoneck

    1965 65hp merc btdc acurate number

    Ok so I am preparing to check timing after cleaning carbs n points ...I found the manual states btdc being 2.00 i also saw it somewhere as 0.02 so im a little confused does anyone know what the number actuall is for sure when setting the max advance i beleive after tdc and setting dial indicator...
  8. brnschoneck

    good manual with good pics....

    Hi all I have a selco manual however as i started wrking on my spare motor 65 65hp merc 180something number I noticed the pics stink ,and wording is hard to understand for a illiterit guy like me lol, and they leave a lot of stuff out for this motor ??? ...Looking for some suggestion on some...
  9. brnschoneck

    testing stator n rectifier???

    motor is a 65 65hp merc...I am only pushing 12.45 volts when running? ??I am thinking it isn't charging rght ....what ohm should staor read testing two yellow wires seloc manual doesn't say for this motor ...It has a old recticier wich I think is bad but numbers are wore off so I can't tell...
  10. brnschoneck

    shift shaft seal n reverse lock cam

    ok I am replacing the shift shaft seal what is the best way to know the reverse lock cam is on the right way ..manual isn't very spacific on this part..I see it says top but how is it supposed to b positioned and work? ???it is a 1965 65 hp mercury type one ...
  11. brnschoneck

    62 mfg opinions is this a tinnie ???

    (EDIT removed email address) i am thinking about getting this i cant find thread i started on it so here goes again !!!! if i can get him low enough dont know much about this company wantedsome opinions ??? Also what is the most you would give for this ...
  12. brnschoneck

    lower unit gear oil whatcha think ???

    ok so this oil is from ooo oct or so changed it today ..no water came out first , but looks real dirty to me is this normal or do u think i need to look at maybe a seal job ??? I did preassure test it and didnt appear to be leaking anywhere but it does look a bit milky/brown to me not sure...
  13. brnschoneck

    work story r peopl that miserable

    so we had a tenant come home while we were trying to fix her dishwasher brand new mind you ,as a rule we are getting renovations done so had to call them so it took a few days anyhow lady says its not fixed yet this is rediculous i pay to much money blahblah blah i want compensation !!!Dont...
  14. brnschoneck

    MMI mech.. school

    ok so my wife is getiing a promotion i am thinking about attending mmi as i luv boats that much on top of what i know and learn everyday !!Does anyone know how much it cost and or how good of a school it really is ?? I think i can do well in this buisness just being a honest person and not...
  15. brnschoneck

    call a/c wont work on mon .. huh ???

    so im a maint. tech and we get a call mon. such n such a/c wont work its frozen ??? so upon further trouble shootng compressor was bad so we replaced it wighed in all freon according to manufactuor specs in heat mode 44 out today , call again today froze up so i tell her well hard to get...
  16. brnschoneck

    PRIMER bulb "PRIMING"

    hi all !!on my 65 merc 650 kf When priming my motor to start wen cold after sitting so u just pump all the air out ?? I been doing a couple xtras not sure exactly dont wanna cause flooding pronblems just wanna make sure i amd oing it right thansk once again for all ur responses ...
  17. brnschoneck

    running additives ,and proper mixture ???

    Ok so ive heard that this ethanol gas in not made for the older outboards such as mine 1965 merc 650 kfier?? I was wondering if i should add a octane booster ,or sumn else to help keep carbs clean , and motor running swell as i am anal about my boat and its performance ?? seems to be fine but...
  18. brnschoneck

    Battery jumper ???

    OK SO IN THE BACK COMPARTMENT OF MY 1978 BUMBLEBEE , i HAVE TWO BATTERIES ONE ON EACH SIDE. SOMEONE INSTALLED WHAT LOOKS LIKE A JUMPER WICH IS A COPPER PEICE WITH TWO POST ??? FROM WHAT I KNOW TO RUN PARRARELL OR SERIES U RUN BATTERY TO BATTERY WHY WOULD THEY HAVE ADDED THIS COPPER POST WITH...
  19. brnschoneck

    nc boaters ????

    hi yall any boaters on here in raleigh nc area lookn to meet some fellow boaters in the area on the lake this year ??me and my wife we are around 35 looking for some other couples to hang/boat etc.... :joyous:
  20. brnschoneck

    looking for somewhere to start ???

    hi yall im just looking for some suggestions not perfection here .. i have a 1978 14ft bumble bee with a 1965 merc 650 outboard on it the prop is old n damaged i cant pull any numbers off it ..I basically cruise n fish does anyone have a similiar setup i am looking to replace the prop not sure...
Top