Search results

  1. H

    throttle cam poition johnson 150.

    I'm guessing my screw came loose and moved my cam roller arm. is this the correct position? 1/16 away from timing advance? thanks sorry I don't have a manual and reading posts wasn't clear to me. thanks again
  2. H

    johnson 150 pulse limiter

    Should I ever have to replace the pulse limiter on the Johnson 150 it's a 99 I am suspecting my fuel pump to be shot as I have to pump the primer to keep it going but could it be the pulse limiter? it's clear when I blow through it and when covering it with my finger while cranking I feel air...
  3. H

    johnson 150 fuel issue?

    hey guys I have a Johnson 150 and it is not running right at all. It will not start right up unless I prime the bulb every time I start it on the hose. It will only stay running for a few minutes and doesn't idle smooth. The only way it stays running is if I pump the primer bulb. I can see...
  4. H

    johnson 150 running rough

    Johnson 150 1999 is running really rough then just stalls out. Initially I thought it was the shift interrupter switch as it was stuck. I disconnected this switch and it started right up. revved a couple times on the hose then stalls out. sounds like its coughing for fuel then dies. I then have...
  5. H

    manual primer valve vro disconnected

    I have a Johnson 150 vro disconnected. which position should the red manual primer valve be in up or down? thanks.
  6. H

    1999 johnson 150 not firing all cylinders

    ~~Hey guys, I have a 1999 Johnson 150 I was running the boat yesterday and while out on the lake it seemed like it lost power then it wouldn't make it home. it did not over heat I have two temp gauges and the fuel was mixed properly. Today I tore down the carbs cleaned them also cleaned fuel...
  7. H

    95 johnson 150 o ring gasket issues

    I have an over heat issue here... I thought it was the water pump/thermostats but it is now pumping good water and the issue is still there. The right side heats up more than the left but they do both heat up too much after only a few minutes of idle. I pulled the one head, o rings looked old...
  8. H

    Johnson 150 head torque specs

    Anyone know the head torque on a 1995 johnson 150. Also need the powerhead torque specs. No model number sorry.
  9. H

    Johnson 150 overheat

    I have a Johnson 150 1995 I think and it overheats. idle for 5 minutes and alarm goes off. Water pressure at idle is 3 pounds maybe and when reved to 4000 at idle pressure goes to 15 or so. I just hooked the alarm back up and I am worried that the engine is damaged I used the boat for ten...
  10. H

    95 johnson 150 alarm

    I have a chance to buy a suzuki 3 wire alarm will this work for my harness? my old alarm was a 3 wire will this work for me thanks?
Top