Search results

  1. 8

    Where does the 12v change to 24v?

    I just picked up an 88 Stratos with 150hp Johnson an it has a Evinrude trolling motor. It says 24v on the motor, turns slow because of only 12v at the motor. Both new batteries have separate black an red cables that go to the front. Two large red and one large black go into a large receptacle...
  2. 8

    115 johnson Water pump, mallory dont match.

    I just received my water pump through the mail, and have discovered that my housing (that I didn't think I needed to replace) is somewhat smaller than the Mallory that I thought was "just better quality". Its the ONLY thing that I didn't order with the kit! Anybody know if I can still use the...
  3. 8

    115 Johnson Pin missing is from where?

    85 Johnson this pin showed up on the table after I removed the bearing carrier, and also the cover for the drive shaft. There were none missing in those two items.... Y'all got any other ideas?:peep:
  4. 8

    I have an extra part, or not. 115 johnson gearcase

    Replacing the water pump, seals in the bearing carrier, and drive shaft seals. I took them apart and will have no problem replacing them with assistance of my manual. While inspecting what I have apart, I noticed a small pin about 1 1/2 inches long on the table. Tapered on both ends.... "Maybe...
  5. 8

    85 Johnson 115 hp Leaking gear oil inside prop housing

    I just tested with soapy water and a radiator pump, the gear case which would only hold about 4lbs of pressure before bubbles started coming from the area on the outside of the 4 bolts in the prop housing. Looking inside from the rear the prop seal itself looks good. Its like the bearing carrier...
  6. 8

    Gear oil leaking maybe from bearing housing

    I have a 85 Johnson 115 that seems to be leaking gear oil from under the seal on the prop shaft itself. I removed the prop, and the seal on the shaft looks to be much dryer than the bottom of the housing. I haven't ran the engine on the water yet due to my "distrust of the facts" from the...
  7. 8

    Removing the gear case on a 84 115 Johnson

    I have a leaky seal, and haven't a clue on removing the gear case. I see 4 bolts in front + 1 bolt in the rear on a small block. Don't know what to expect next, or if I should have engine tilted or not ?.... Is the shift rod and drive shaft going to be a surprise? I work in maintenance, but have...
Top