Search results

  1. E

    Need a little help with spark plugs

    For My 1984 evinrude 35hp. I went to westMarine and they sold Me NGK BR7HS 10 but I removed a set of spark plugs from the previous owner with a different part #. Are the ones i got the best spark plugs for this OB.
  2. E

    84 evinrude 35hp timing

    I went back to the boat with the timing gun and hook it to the top spark plug cylinder, then I removed both plugs and grounded the bottom wire. I marked the flywheel at 26 degrees and set the timing gun to advance at 26 degrees as well, cranked the engine and it was off by far too retarded, so I...
  3. E

    1984 evinrude 35hp ignition issue

    Well today I had a chance to finally take the boat out for a couple of hours, it started fine and (thanks to some very helpful members from this forum) the new propeller performed very nicely. I do however have a ignition problem, it will randomly cut out at low rpms, I put the spark tester at...
  4. E

    84 Evinrude 35hp ?

    Finally after much work and thanks to this forum knowledgeable members I got the motor back together and drove to the bay for a test. I'm glad the motor now starts and runs, of course, I found a few problems. 1- The engine will cut off randomly for a fraction of a second and then continue as if...
  5. E

    1984 Evinrude 35hp

    I finally got some time to work on the new to Me evinrude I had to rebuild shortly after I purchased it, today I pumped some fuel in it and after some cranking I got it to fire up. I checked the spark prior to this and seemed weak to Me, then I tried to time it in case I moved something during...
  6. E

    Kill switch

    I have a 1984 Evinrude 35hp E35ELCRR I'm rebuilding and while doing this I have tried to repair some of the damage inflicted on the electrical system of this outboard, I have added a start switch, a fuse on the positive side of the charging system and solder new wires wherever needed. One thing...
  7. E

    1984? Chrysler sea king parts

    I have a montgomery ward sea king by Chrysler 7.5hp model vwb52179e in great shape but I think it needs a water pump kit, I was searching for parts and I can't find them. I tried boatnet website and there isn't a section for Chrysler at all, how do I tell which one it is? Thanks.
  8. E

    Anaerobic sealant

    I waiting for some parts to show up here and I got everything cleaned and ready to assemble when they do for My 84 evinrude 35hp, I was told to use the anaerobic sealant when I put the crankcase together and the HG as well, I went to Advance auto, Autozone and TSC but no one has it is there...
  9. E

    1984 evinrude 35 still wont start

    Since last thread I went back to the motor and removed almost every wire that looked old or fried, I removed the carburetor and cleaned it (it was clean anyways) then I set the low idle needle back to 1 3/4 turn cranked the engine with both spark plugs out and they have plenty of spark, also...
  10. E

    1984 evinrude 35hp starting problem

    Hello I'm EZ from Maryland, I'm a newbie boater and learning about 2 stroke for some time now.:happy: I have a problem with a new to Me outboard (evinrude 35hp model e35elcrr remote throttle and shifter), it ran fine but only seems to start in full throttle and when it does start after a few...
Top