Search results

  1. P

    Leveler Cable Sheaves for an old "Station Master" 2600# Vertical Lift

    I need to replace the leveling cable sheaves on an old "Station Master" 2600# vertical lift. I can't find any information on "Station Master". A Hewitt dealer in the Finger Lakes area told me today that the company did exist and built their own lifts. It looks like a knock-off of a Hewitt lift...
  2. P

    In stock Piston 777-9009T13?

    Anyone have a recommended source for this piston that is in stock? I guess I could also settle for a good after-market one if I have to. Also the powerhead bottom gasket 27-43007 5 seems to be hard to come by. Wanted to finish a rebuild next week... S/N 0D037391 1991 75hp 3 cylinder...
  3. P

    Flex/Ball Hone for 3 3/8" cylinder?

    Does a 3 3/8" flex hone exist? If not, would 3 1/4 or 3 1/2 be better. Just looking to deglaze and possibly remove some transferred alluminimum on one cylinder. Anyone know if Tidy Bowl or Muriatic Acid is safe to use on a 1991 75hp 3 cyl 2-stroke mercury?
  4. P

    Northern Virginia /DC area machine shop recommendation

    I need at a minimum to have a 1991 75hp 2-stroke cylinder re-honed and maybe bored out and re-honed. Anyone have a recommendation? I live in Herndon, if you are familiar with the area. Thanks in advance, Greg
  5. P

    "Rod Knock" Turns out to be top cylinder piston slap - what caused and how to fix it?

    "Rod Knock" Turns out to be top cylinder piston slap - what caused and how to fix it? Hi All, My posts started out with questions about a knocking noise - see previous posts for background if interested. Anyway, I pulled the crankshaft and pistons out (1991 75hp 2-stroke) and the top piston...
  6. P

    HELP Can't pull 1997 3 cylinder 75Hp Power Head - More than 8 bolts?

    Hi, [Edit - that should have been 1991 not 1997] I have the 8 bolts that connect the exhaust housing to the power head out (3 on each side, two on the back) and have pulled on the lifting ring hard enough to almost lift the boat off the trailer or at least take up the trailer suspension. I...
  7. P

    Considering Limited Rebuild of 1991 75hp 2-stroke - cylinders OK?

    My outboard has developed some rod knock that sounds like a piston pin. It is only one cylinder from looking at the audio waveform. I have other posts on this. Anyway, I'm waiting on the flywheel puller/lift ring tool since I can't figure out how to get the crankcase cover off with the block...
  8. P

    How to disconnect the upper shift shaft on a 1991 75 hp mercury outboard

    It looks like the shift shaft is epoxied to the arm at the top of the shift shaft. - see picture. Was this a repair or do you have to remove the power head to get it out? Any advice on getting it out without removing the power head would be greatly appreciated. By the way is there any way to...
  9. P

    1991 Mercury 75hp 2-stroke power head "knocking" or "banging" noise

    1991 Mercury 75hp 2-stroke power head "knocking" or "banging" noise Engine starts and runs at all speeds OK (not really smooth acceleration) - would describe noise as tappet noise if the engine had valves. Engine is oil injected - may have a weak fuel pump. The noise seems to occur once per...
Top